Sun Microsystems X4200 M2 Installing the Mounting Brackets Onto the Server, Mounting bracket

Installing the Mounting Brackets Onto the Server

Use this procedure to install the mounting brackets onto the sides of the server.

1.Position a mounting bracket against the chassis so that the slide-rail lock is at the server front, and the three keyed openings on the mounting bracket are aligned with the three locating pins on the side of the chassis. See FIGURE 1-2.

Chassis front	Mounting-bracket clip
Slide-rail lock	Mounting bracket

FIGURE 1-2Aligning the Mounting Bracket With the Server Chassis

2.With the heads of the three chassis locating pins protruding though the three keyed openings in the mounting bracket, pull the mounting bracket toward the front of the chassis until the mounting-bracket clip locks into place with an audible click. See FIGURE 1-2.

3.Verify that all three locating pins are trapped in the keyed openings and that the rear locating pin has engaged the mounting-bracket clip. See FIGURE 1-2.

4.Repeat the procedure to install the remaining mounting bracket on the other side of the server.

4 Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Installation Guide • May 2007