Sun Microsystems X4200 M2, X4100 M2 manual Installing the Cable Management Assembly

4.Simultaneously pull and hold the slide rail release buttons on each mounting bracket while you push the server into the rack. See FIGURE 1-4.

Continue pushing until the slide-rail locks on the front of the mounting brackets engage the slide-rail assemblies.

Caution – Verify that the server is securely mounted in the rack and that the slide- rails locks are engaged with the mounting brackets before continuing.

Installing the Cable Management Assembly

Use this procedure to install an optional cable management assembly (CMA).

1.Unpack the CMA parts.

2.Take the CMA to the rear of the equipment rack and ensure that you have adequate room to work around the rear of the server.

Note – References to “left” or “right” in this procedure assume that you are facing the rear of the equipment rack.

3.Locate the CMA rail extension and insert it into the left slide-rail until the extension locks into place with an audible click. See FIGURE 1-5.

Left slide-rail

CMA rail extension

FIGURE 1-5Inserting the CMA Rail Extension Into the Rear of the Left Slide-Rail

Chapter 1 Setting Up the Server Hardware 7