Sun Microsystems X4200 M2, X4100 M2 manual Installing the Server Into the Slide Rail Assemblies

Installing the Server Into the Slide Rail

Assemblies

Use this procedure to install the server chassis, with mounting brackets, into the slide-rail assemblies that are mounted to the rack.

Caution – This procedure requires a minimum of two people because of the weight of the server. Attempting this procedure alone could result in equipment damage or personal injury.

1.Push the slide-rails into the slide-rail assemblies as far as possible.

2.Raise the server so that the rear ends of the mounting brackets are aligned with the slide-rail assemblies that are mounted in the equipment rack. See FIGURE 1-4.

3.Insert the mounting brackets into the slide-rails, then push the server into the rack until the mounting brackets encounter the slide-rail stops (approximately 12 inches or 30 cm).

Slide-rail assembly mounted on rack post

Mounting bracket inserted into slide-rail

Slide-rail	Slide-rail locks
release button

FIGURE 1-4Inserting the Server With Mounting Brackets Into the Slide-Rails

6 Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Installation Guide • May 2007