Sun Microsystems CP32x0 manual About Installing and Removing, Artm-Hd

Page 32

2.1About Installing and Removing the

ARTM-HD

The ARTM-HD can be installed into an ATCA shelf (chassis) with a midplane made for front and rear board installations (FIGURE 2-1). The module must be installed in the slot directly behind the Netra ATCA node board. These back-to-back slots have common pins to enable passing of signals.

Note – Connectors on previous blade servers do not mate with connectors on the ARTM-HD.

Before installing the ARTM-HD, verify the module’s part number to ensure that the correct ARTM-HD is being installed into the system. For information on identifying the ARTM-HD, see Section 1.10, “Part Number, Serial Number, and FC Address Labels” on page 1-13.

Caution – Use the ARTM-HD only with compatible blade servers. Attempts to install the ARTM-HD with an incompatible blade server might cause damage to themselves and the blade server.

2-2Netra CP32x0 SAS Storage Advanced Rear Transition Module HD User’s Guide • January 2009

Image 32
Contents Sun Microsystems, Inc Please Recycle Contents Disk Management 3-1 3.1 RAID Support Index Index-1 Page Figures Page Tables Page Preface How This Document Is OrganizedUsing Unix Commands Shell PromptsTypographic Conventions Related Documentation Sun Welcomes Your Comments Documentation, Support, and TrainingThird-Party Web Sites Page Overview Features of the ARTM-HD Picmg Standards Compliance Airflow Cooling RequirementsPressure Drop Rates ARTM-HD Component Diagram 1Netra CP32x0 ARTM-HD ComponentsI/O Interfaces 3Netra CP32x0 ARTM-HD I/O Configurations Hard Disk Drives Hard Disk Drive ControllerExternal SAS Connectors 3Connecting to an External Disk Array4Connecting to Another Artm LEDsSoftware Support LEDsPage Part Number, Serial Number, and FC Address Labels Part number label Serial number labelPage Installation and Service About Installing and Removing ARTM-HD1Installing the Blade Server and ARTM-HD Into the Atca Shelf Installing the ARTM-HD Retention screw Injector/ejector latch 3Holding the ARTM-HD During Installation 4Inserting the ARTM-HD Power on the system, if necessary Removing the ARTM-HD 5Removing the ARTM-HD Installing a Hard Disk Drive Removing a Hard Disk Drive6Jumper setting for red OOS LED P1/P2 Changing the OOS LED ColorReinstall the ARTM-HD Page Disk Management SAS Bios Overview RAID SupportStarting the SAS Bios Configuration Utility Creating a RAID 0 Volume Creating a RAID 1 Volume Creating a RAID 1E Volume Viewing RAID Volume Properties Synchronizing an Array Activating an ArrayDeleting an Array Locating a Disk DrivePage Specifications and Connectors Specifications for the ARTM-HD Physical DimensionsHardware Descriptions Ethernet Management PortConnectors and Pin Assignments 1shows the location of the connectors1 I/O Connectors Serial Port SAS Connectors Zone 3 Connectors 4lists the Zone 3, J31 connector pinouts 6lists the Zone 3, J33 connector pinouts Bios SAS RAID Index