Sun Microsystems CP32x0 manual Hard Disk Drives, Hard Disk Drive Controller

Page 24

1.5Hard Disk Drives

The ARTM-HD supports up to two SAS hard disk drives (HDs) with the following features:

2.5” server-grade HDs, mounted in a NEMO bracket

146 GB capacity at 10K RPM

hot-swappable

1.6Hard Disk Drive Controller

The ARTM-HD includes an LSI SAS 1068e hard disk drive controller with the following features:

8 lane PCIe interface (full duplex 2.5Gb/sec)

8 SAS ports (3.0Gb/sec) with 4 ports to the external connectors, 2 ports - 1 to each HD, and 2 ports to the Zone 3 connector (1 to each AMC).

LSI Integrated hardware RAID support for RAID 0, RAID 1, and RAID 1E.

1-8Netra CP32x0 SAS Storage Advanced Rear Transition Module HD User’s Guide • January 2009

Image 24
Contents Sun Microsystems, Inc Please Recycle Contents Disk Management 3-1 3.1 RAID Support Index Index-1 Page Figures Page Tables Page Preface How This Document Is OrganizedUsing Unix Commands Shell PromptsTypographic Conventions Related Documentation Documentation, Support, and Training Third-Party Web SitesSun Welcomes Your Comments Page Overview Features of the ARTM-HD Picmg Standards Compliance Airflow Cooling RequirementsPressure Drop Rates ARTM-HD Component Diagram 1Netra CP32x0 ARTM-HD ComponentsI/O Interfaces 3Netra CP32x0 ARTM-HD I/O Configurations Hard Disk Drives Hard Disk Drive ControllerExternal SAS Connectors 3Connecting to an External Disk Array4Connecting to Another Artm LEDsSoftware Support LEDsPage Part Number, Serial Number, and FC Address Labels Part number label Serial number labelPage Installation and Service About Installing and Removing ARTM-HD1Installing the Blade Server and ARTM-HD Into the Atca Shelf Installing the ARTM-HD Retention screw Injector/ejector latch 3Holding the ARTM-HD During Installation 4Inserting the ARTM-HD Power on the system, if necessary Removing the ARTM-HD 5Removing the ARTM-HD Installing a Hard Disk Drive Removing a Hard Disk Drive6Jumper setting for red OOS LED P1/P2 Changing the OOS LED ColorReinstall the ARTM-HD Page Disk Management SAS Bios Overview RAID SupportStarting the SAS Bios Configuration Utility Creating a RAID 0 Volume Creating a RAID 1 Volume Creating a RAID 1E Volume Viewing RAID Volume Properties Synchronizing an Array Activating an ArrayDeleting an Array Locating a Disk DrivePage Specifications and Connectors Specifications for the ARTM-HD Physical DimensionsHardware Descriptions Ethernet Management PortConnectors and Pin Assignments 1shows the location of the connectors1 I/O Connectors Serial Port SAS Connectors Zone 3 Connectors 4lists the Zone 3, J31 connector pinouts 6lists the Zone 3, J33 connector pinouts Bios SAS RAID Index