Sun Microsystems CP32x0 manual Installing the ARTM-HD

Page 34

2.2Installing the ARTM-HD

The ARTM-HD must be used with a Netra ATCA node board for rear I/O access. The ARTM-HD enables access to the network, to a boot device, and to a console terminal.

Note – The ARTM-HD and the corresponding Netra blade server can be installed while the shelf is powered—however, start with a powered shelf only if you must do so.

Note – Optimally, install the ARTM-HD before installing the corresponding Netra blade server. This order ensures proper bring up of the ARTM-HD firmware.

1.Verify that you have taken the necessary antistatic precautions.

2.Go to the back of the system and choose an appropriate slot for the ARTM-HD.

ARTMs must be installed inline behind the accompanying blade server. For example, if the accompanying blade server is going to be installed in

slot 3, its ARTM must be installed at the back of the system in slot 3.

3.Remove the slot filler panel from the selected blade server slot, if necessary.

4.Prepare the module by loosening the locking screws and opening the injector/ejector latch at the top of the module (FIGURE 2-2).

2-4Netra CP32x0 SAS Storage Advanced Rear Transition Module HD User’s Guide • January 2009

Image 34
Contents Sun Microsystems, Inc Please Recycle Contents Disk Management 3-1 3.1 RAID Support Index Index-1 Page Figures Page Tables Page Preface How This Document Is OrganizedUsing Unix Commands Shell PromptsTypographic Conventions Related Documentation Third-Party Web Sites Documentation, Support, and TrainingSun Welcomes Your Comments Page Overview Features of the ARTM-HD Picmg Standards Compliance Airflow Cooling RequirementsPressure Drop Rates ARTM-HD Component Diagram 1Netra CP32x0 ARTM-HD ComponentsI/O Interfaces 3Netra CP32x0 ARTM-HD I/O Configurations Hard Disk Drives Hard Disk Drive ControllerExternal SAS Connectors 3Connecting to an External Disk Array4Connecting to Another Artm LEDsSoftware Support LEDsPage Part Number, Serial Number, and FC Address Labels Part number label Serial number labelPage Installation and Service About Installing and Removing ARTM-HD1Installing the Blade Server and ARTM-HD Into the Atca Shelf Installing the ARTM-HD Retention screw Injector/ejector latch 3Holding the ARTM-HD During Installation 4Inserting the ARTM-HD Power on the system, if necessary Removing the ARTM-HD 5Removing the ARTM-HD Installing a Hard Disk Drive Removing a Hard Disk Drive6Jumper setting for red OOS LED P1/P2 Changing the OOS LED ColorReinstall the ARTM-HD Page Disk Management SAS Bios Overview RAID SupportStarting the SAS Bios Configuration Utility Creating a RAID 0 Volume Creating a RAID 1 Volume Creating a RAID 1E Volume Viewing RAID Volume Properties Synchronizing an Array Activating an ArrayDeleting an Array Locating a Disk DrivePage Specifications and Connectors Specifications for the ARTM-HD Physical DimensionsHardware Descriptions Ethernet Management PortConnectors and Pin Assignments 1shows the location of the connectors1 I/O Connectors Serial Port SAS Connectors Zone 3 Connectors 4lists the Zone 3, J31 connector pinouts 6lists the Zone 3, J33 connector pinouts Bios SAS RAID Index