Sun Microsystems Sun Quad manual Setting Parameters in the /etc/system File

TABLE B-8

TABLE B-1

Setting Parameters in the /etc/system File

To configure the qfe driver parameters for all SUNW,qfe devices in the system so that the parameter variables are always effective (even after rebooting the system), enter the parameter variables in the /etc/system file. When you reboot the system, the system reads the /etc/system file and sets these parameter variables in the qfe module in the operating system kernel.

TABLE B-9lists the variables you can set in the /etc/system file.

TABLE B-9Setting Variables in the /etc/system File

Parameter	Variable
ipg1	qfe_ipg1
ipg2	qfe_ipg2
use_int_xcvr	qfe_use_int_xcvr
pace_size	qfe_pace_size
adv_autoneg_cap	qfe_adv_autoneg_cap
adv_100fdx_cap	qfe_adv_100fdx_cap
adv_100hdx_cap	qfe_adv_100hdx_cap
adv_10fdx_cap	qfe_adv_10fdx_cap
adv_10hdx_cap	qfe_adv_10hdx_cap
lance_mode	qfe_lance_mode
ipg0	qfe_ipg0

These parameter values, described in “Driver Parameter Values and Definitions” on

page 24, are applicable to all SUNW,qfe devices on the system. See through for the descriptions of these parameters.

Appendix B Configuring the Quad FastEthernet Device Driver Parameters 35