Sun Microsystems X1150A View the.properties file for a list of device properties, Ok .properties

4.View the.properties file for a list of device properties.

It might be difficult to tell if the devices on your network are GigaSwift Ethernet devices or other network interface cards. The.properties command displays the specific information about the installed adapter.

At the ok prompt, use the .properties command to make sure that the device you just installed is connected to the network. Your output may look different from the following example:

ok .properties
assigned-addresses	82002010	00000000 01000000 00000000 00200000
	82002030	00000000		01200000 00000000 00100000
d-fru-len	00 00 00	00
d-fru-off	00 00 e8	00
d-fru-dev	eeprom
s-fru-len	00 00 08	00
s-fru-off	00 00 e0	00
s-fru-dev	eeprom
compatible	70 63 69	31	30 38	65 2c 61 62 62	61 2e 31 31 00
reg	00002000	00000000 00000000 00000000 00000000
	02002010	00000000		00000000 00000000 00200000
	02002030	00000000		00000000 00000000 00100000
address-bits	00 00 00	30
max-frame-size	00 00 40	00
network-interface-type ethernet
device_type	network
name	network
local-mac-address	08 00 20	aa bb cc
version	Sun PCI Gigaswift 1000Base-T FCode 2.11 02/09/23
phy-type	mif
board-model	501-5525
model	SUNW,pci-ce
fcode-rom-offset	00000000
66mhz-capable
fast-back-to-back
devsel-speed	00000002
class-code	00020000
interrupts	00000001
	00000002
	00000003
	00000004
max-latency	00000040
min-grant	00000040
revision-id	00000011
device-id	0000abba
vendor-id	0000108e

18 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • February 2003