Network Technologies 900GV manual Conventions, Convention Description, Boldface

Page 10

Conventions

Conventions

This book uses the following conventions.

Convention	Description

NOTE	Contains information of special interest.
Special Type	Indicates system output in examples.
Boldface	Indicates user input in examples.
<Return>	Indicates that you should press the Return key.

x

Image 10

Contents

Digital VNswitch 900GV Installation and Configuration Revision InformationAchtung Contents Installing the Digital VNswitch 900GV Removing the Cables, Connector and Module Page Purpose of the Manual PrefaceOverview Intended AudienceOrganization Section DescriptionAssociated Documents Title and Order DescriptionConvention Description ConventionsBoldface Online Services Accessing Online InformationDocumentation Comments Page Safety AchtungThis action deletes all configured settings and replaces This Chapter Chapter Product IntroductionTopic What is the Digital VNswitch 900GV? Configuration and Management FeaturesHot Swap Bridging EthernetMibs Vlan Secure Domains Chapter Installing the Digital VNswitch 900GV IntroductionFront Panel Components Front Panel LEDs and ConnectorsModule Components Icon Name DescriptionFRU LED Back Panel Components Back Panel ComponentsName Description How to Install the Module Task 1 Compare the Power RatingsTask 2 Seat the Module Step ActionIf… Then… Task 3 Verify Initial LED OperationStage Description Task 4 Connect the LDM Port Cable 5LDM Port Cable ConnectionTask 5 Connect the Gbic Connector 6GBIC ConnectionLong Wave Length Blue HP 5611 Task 6 Connect the Duplex SC CablesFiber Size Fiber Bandwidth Distance Chapter Installing the Setup Port Cable Setup Port Device Cabling Setup Port Signaling StandardsIf the setup port device is… Use this cable… Connecting to the Setup Port Item Description1Setup Port Cabling Components Configuring the Module in a Digital MultiSwitch ChapterAssigning an IP Address Digital MultiSwitch 900 Installation Menu Redirect ModeStart Redirect Mode Using Menus to Configure the Module Restart with Factory Defaults Restart with Current Settings Restart with Current SettingsShow Current Settings Configure IP IP ConfigurationTopic Set Snmp Read/Write Community SET Smnp READ/WRITE CommunityLine Field Description Add Snmp Trap AddressesADD Snmp Trap Addresses Delete Snmp Trap Addresses Delete Snmp Trap AddressesIN-BAND Interface IP Address Configuration Set In-Band Interface IP AddressOUT-OF-BAND Interface IP Address Configuration Set Out-of-Band Interface IP AddressSet Default Gateway SET IN-BAND Interface Default Gateway AddressGo to Local Console Product-Specific Options VNswitch 900GV Options from the VNswitch 900GV Installation MenuProduct-Specific Options MultiSwitch PRODUCT-SPECIFIC OptionsPage Removing the Cables, Connector and Module Removing the Cables 1Removing the LDM Port CableRemoving the Gbic Card Gbic RemovalUnseating the Module 3Unseating the ModuleAppendix a Problem Solving This AppendixNormal Power-Up Event DescriptionTable A-1Module LED States LED DescriptionsOff On Green On Yellow Flashing LED Name Off On Green On Yellow Flashing Problem Solving Using LEDs Symptom Probable Cause Corrective Action Appendix B Connector Pin Assignments and Adapters Connectors and Pin Assignments 10BaseT Port 8-pin MJ Straight-through ConnectorAdapters H8571-J AdapterH8575-A Adapter Figure B-3 H8575-A AdapterAppendix C Product Specifications Product Specifications Table C-1 Product Specifications ParameterTable C-2Acoustical Specifications Acoustical SpecificationsTable C-3German Acoustical Specifications Connectors Table C-4 Connectors Quantity