Sun Microsystems 2000E Removing the Side Panels, 2Removing the Vented Front Panels

Page 45

A

Figure 1-2Removing the Vented Front Panels

A.1.3 Removing the Side Panels

To remove the left and right side panels:

1.Loosen two slot-head captive screws near the panel base.

2.Tilt the panel bottom out.

Access

A-3

Image 45
Contents SPARCcenter 2000E Power Supply Installation Manual Trademarks Contents SPARCserver 2000E Power Supply Installation Manual-April Figures SPARCserver 2000E Power Supply Installation Manual-April Tables Viii Power Supply Installation, explains how to perform PrefaceHow This Book Is Organized Application Title Part Number Related DocumentsWhat Typographic Changes Mean Shell Prompts in Command ExamplesXii Before You Start Safety PrecautionsProblem Precaution SymbolsOFF Tools Required Power Supply Installation Open Boot Prom Powering Down the SystemOperating System OnDiagnostics Secure Standby Access Installing the Bottom Power SupplyIdentifying a Redundant-Capable Cabinet Installing the Supply Disconnect the top power supply power cordPreparation 4Disconnecting the Top Power Supply Power Cord Remove the power supply cage cover panelRemove the AC Distribution Unit Remove the Breaker Box Filter Cable Power Supply Physical InstallationPower supply cage Screws 6 places Main Bus Bar Installation Install the bottom cover panelTighten all nuts and screws installed in and Step 12Installing the Main Bus Bar Power Harness Installation+12V +12V Return Power harness Part Plug in the filter cable Cabling16Replacing the Power Breaker Box Place the breaker box against power supply cage17Connecting the Power Cords Plug it into J1 near the top of the supply Power Supply Sense Cable19Replacing the Power Supply Compartment EMI Panel Restore the SystemRestarting the System Turn the key switch to Power-on position. See FigureRemote Local Watch the terminal screen for any Post error messages 21System Reset Switch Reading Boot MessagesDC power green Fault yellow System running green Bottom Top Power Supply SPARCserver 2000E Power Supply Installation Manual-April Access Removal ProceduresOpening the Hinged Door 1Opening the Hinged Door Removing the Vented Front Panels2Removing the Vented Front Panels Removing the Side Panels3Removing the Side Panels Removing the EMI Shield4Removing the EMI Shield Rear Screen PanelEMI Panel Closing the SystemSide Panels Vented Front PanelSPARCserver 2000E Power Supply Installation Manual-April Revision History SPARCserver 2000E Power Supply Installation Manual-April Reader Comments Business Reply Mail