![](/images/new-backgrounds/1174824/17482421x1.webp)
5.Remove the
DC POWER
TERMINALNegative
Terminal
Ring | NEGATIVE |
Terminal | POWER LEAD |
|
6.Connect both power leads to a fuse panel. The negative
CAUTION:
Observe proper polarity.
The power source(s) connected to the 4000E must be equipped with a disconnect device such as an On/Off switch. Otherwise, an appropriately rated circuit breaker must be installed on each power circuit to be used. In the case of an emergency, hazardous voltages will not be removed from the 4000E until all power sources have been either turned off or disconnected from the chassis.
7.Turn your power source(s) on. The PWR (power) LED on both the interface module and management module faceplates will illuminate solid green to indicate the modules are receiving power.
Management Module Power LED | Interface Module Power LED |
July 2005 | 11 |