Paradyne 4000E installation instructions Interface Module B Interface Module a Connectors

Page 13

the A connectors provide the subcriber connections for ports 1-12 and the B connectors provide the subscriber connections for ports 13-24.

4000E REAR VIEW

Interface Module B

Interface Module A

connectors

Connectors

Subscriber connections for ports

Subscriber connections for ports

25-48 (on applicable models)

1-24 (on most models)

2.Detach the hook-and-loop fastener Strap from the female RJ21 connector port: lift the hook-and-loop fastener tab from the bottom and pull the strap upward to open, leaving it looped under the right side of the connector frame.

FEMALE RJ21 CONNECTOR A

FOR INTERFACE MODULE SLOT 3

3.Slide the male RJ21 connector of your interface cable underneath the hook-and-loop fastener, from the left, and press it firmly into the female RJ21 connector port on the chassis.

MALE RJ21 CONNECTOR OF

YOUR INTERFACE CABLE

IPD4-A2-GZ40-10

July 2005

13

Image 13
Contents Software and Firmware License Agreement ContentsJuly IPD4-A2-GZ40-10 Unpacking and Inspecting the Equipment IntroductionInstallation on a Tabletop Installation OptionsInstallation in a Rack Installing a Management Module Installing Your Management ModuleInstalling Your Interface Modules Interface Module Powering Up Your 4000E BLC DC Power Terminal DC Power Subscriber Lines Uplink ConnectionsInterface Module B Interface Module a Connectors July IPD4-A2-GZ40-10 Configuration and Management Securing the Connecting CablesFan Module Product Documentation Online SpecificationsImportant Safety Instructions United States EMI Notice Canada EMI Notice Warranty, Sales, Service, and Training Information
Related manuals
Manual 20 pages 48.14 Kb