MVL HomeLink

LED Symptom

Action

LINE LED is off.

Verify that the MVL LINE cable is securely installed on both ends. If the problem continues, contact the Service Provider.

Verify that the line has dial tone. If there is no dial tone, contact the Service Provider.

LINE LED is on and	The MVL link has been established but there is no data
there is no data	transmission. Verify the Ethernet connection. If the problem
transmission.	persists, contact the Service Provider.

LINE and Ethernet	The MVL and Ethernet links have been established but there is
LEDs are on and	no data transmission. If the problem continues, contact the
there is no data	Service Provider.
transmission.

PWR LED is off.	Check that the power cord is securely installed on both ends.

	If no LEDs are on, the power supply may be defective. Test the
	outlet to verify power. If the problem persists, contact the
	Service Provider.

	If other LEDs are on, the PWR LED may be burned out. Unplug
	the unit and reapply power; watch all LEDs during the
	power-on self-test to verify if the PWR LED is functioning.

TST LED is on.	A test initiated by the Service Provider may be active. Wait five
	minutes. If the TST LED does not go off, contact the Service
	Provider.

To improve data transmission throughput and minimize background noise during a telephone conversation, make sure that:

HThe Hotwire 6310 MVL modem is always powered on, even when not in use, and

HA Hotwire MVL phone filter is installed on every telephone.

MVL HomeLink is a feature that provides peer-to-peer communications for PCs attached to different MVL modems at the customer premises.

For example, PCs that are not connected to the same physical Ethernet LAN can now take advantage of the resources of the primary office computer. With the Microsoft Windows operating system, multiple end-user systems can share resources, including:

HFile sharing

HPrint sharing

HSecondary computer backup