Paradyne installation instructions Powering Up Your 12000E

Powering Up Your 12000E

CAUTION:

Turn your DC power source(s) OFF until you have completed connection of the 12000E as outlined in the following sections.

Do not operate the 12000E without a ground connection.

Procedure

1.Connect a ground wire to the 12000E: Line up the 2-hole terminal lug of your ground wire with the two holes on the small, unpainted section on the back of your chassis. Secure the terminal lug to the chassis with two #10-32 screws.

12000E REAR VIEW

Ground Connection for 2-Hole Terminal Lug

GROUND CONNECTION CLOSE-UP

2.Connect the ground wire to a frame ground. Ground wire connection can vary from location to location though typically all equipment in a Central Office is grounded to a common copper bus.

IPD1-A2-GZ40-10 July 2005 11