7.Verify the connection. Turn your power source(s) on. The PWR (power) LED on the interface module and management module faceplates will illuminate solid green to indicate the modules are receiving power.
MANAGEMENT MODULE | INTERFACE | |
MODULE | ||
|
Power LED
Power LED
Establishing Your Uplink Connections
No configuration is necessary for Uplink Interface Modules (UIMs) or Media Interface Modules (MIMs) installed on the management module(s) in your 12000E to operate at default settings. However, if you wish to run your uplink connections at settings other than the UIM or MIM defaults, configure the UIM or MIM prior to connection.
For further connection and configuration information, refer to the installation instructions of your particular UIM or MIM.
Uplink Module
14 | July 2005 |