Paradyne 9783 Verifying that Self-Test Passed, Using the Easy Install Feature

Page 15

Verifying that Self-Test Passed

To verify that the unit passed its self-test, go to the System and Test Status screen.

Main Menu → Status → System and Test Status

The results of the self-test appear directly under the screen title.

If any failure messages appear, reset the unit by disconnecting, then reconnecting the power cord. The unit will perform the self-test again. If the failure reappears, call your service representative for assistance.

Using the Easy Install Feature

An Easy Install screen is provided for custom configurations, but you are not required to use it for normal installation. You can configure the router by making selections from the Configuration Edit/Display menu.

Procedure

1.Select the Easy Install feature.

Main Menu → Easy Install

Easy Install Screen Example

main/easy_install						9783-RtrSLV
Device Name: Node	A		2/26/2001 00:01
			EASY INSTALL
DSLAM Type:				Paradyne
Node		IP Address:	000.000.000.000			Clear
Node		Subnet Mask:	000.000.000.000			Clear
TS	Access: VPI,VCI		0,35

Create a Dedicated			Network Management Link
Ethernet Management Options Screen
Network	1	DSL Line	Rate (Kbps)	AutoRate
Network	1	FRF.8 Encapsulation Mod		Transparent

-----------------------------------------------------------------------------

Ctrl-a to access these functions, ESC for previous menu	MainMenu Exit
Save

15

Image 15

Contents FrameSaver DSL 9783 Router Central Office Customer Premises Remote Site Customer Premises HQ SiteFrame Relay NSPs Network FrameSaver DSL 9783 User’s Guide Package ChecklistUpgrading a Basic Unit to SLV Product Documentation OnlineCable supplied for use in the U.S Wiring and Cables You May NeedInterface Feature Connection Cables Number Ethernet portProvisioning Data Circuits in OpenLane Prior to Installing the RouterInstalling the Router ProcedureDSL 9783 Router Ethernet COM Power-On System OK green Alarm redEthernet Port green Condition Status Status LEDsProvider TroubleshootingLED Symptom Action Unplug the unit, unless instructed to do so by the serviceConfiguration Setup Main Menu Main Menu → Configuration Menu NavigationPress Verifying that Self-Test Passed Using the Easy Install FeatureMain Menu → Easy Install Easy Install Screen ExampleCompleting Setup From the NOC Configuring Snmp Trap Managers and Traps Procedure Setting Up for In-Band ManagementShow config Configuration → Virtual Router Ports → Dlci RecordsChecking That Data is Being Received Procedure Verifying the End-to-End Management PathMain Menu → Status → Performance Statistics → Frame Relay Checking PVC Connections Provisioning the Router InterfaceCables and Connectors Pin Connector Similar to RJ48C Pin # FunctionCable Pin Straight-Through Connections EthernetPin Ethernet Crossover Cable Function Pin # Pin # Function Pin # Signal Direction Connecting an External ModemSpecification DSL Router Technical SpecificationsImportant Safety Instructions EMI Notices CE MarkingGovernment Requirements Warranty, Sales, Service, and Training Information Document FeedbackTrademarks

Related manuals

Manual 166 pages 36.17 Kb

Manual 233 pages 22.17 Kb