Paradyne 9783 installation instructions Status LEDs, Condition Status

Status LEDs

After a successful self-test, the LEDs should appear as indicated in BOLD in the Condition column below.

LED	Condition	Status
System LEDs
OK	ON	The router has power.
ALM	ON	An alarm condition exists.
	OFF	No alarms have been detected by the router.
TEST	ON	The router is performing the power-on self-test, or a test
		initiated by the service provider is currently active.
	OFF	No tests are active.
Network LEDs
ATM	ON – Green	ATM mode is active and cell delineation is in sync.
	ON – Yellow	ATM mode is active and there is loss of cell delineation.
DSL	Blinking	The router is in start-up or is retraining. The LED blinks on
		and off about five times per second.
	ON	The DSL link is ready to transmit and receive data.
	OFF	No DSL link has been established, or the link is down.
Port LED
OK	ON	The Ethernet port is transmitting and receiving data.
	OFF	Self-diagnostics have not been completed successfully.

10