Paradyne 9783 installation instructions Setting Up for In-Band Management

Page 17

Configuring SNMP Trap Managers and Traps

Procedure

To enter SNMP managers and configure traps:

1.Select SNMP Traps.

Main Menu Configuration Management and Communication SNMP Traps

2.Configure the following:

Enable SNMP Traps.

Identify the total Number of Trap Managers.

Specify the IP address for each NMS Trap Manager to which traps will be sent.

Specify the Initial Route Destination for each Trap Manager. The default is AutoRoute.

Select or disable trap categories, as needed.

3.Save the configuration.

Setting Up for In-Band Management

If FRF.8 Encapsulation Mode is set to Translational, remote management of the router can still be accomplished in-band, as indicated in the following procedure.

The following procedure assumes that the router’s Ethernet interface has already been assigned an IP address that is in the same subnet as the management IP address entered in Step 6 on page 16 of Using the Easy Install Feature, and that the router is not configured for bridging only.

Refer to Configuring the FrameSaver DSL Router; CLI Commands, Codes, and Designations, and Command Line Summaries and Shortcuts in the User’s Guide for additional information.

17

Image 17
Contents FrameSaver DSL 9783 Router Frame Relay NSPs Network Central Office Customer Premises Remote SiteCustomer Premises HQ Site Upgrading a Basic Unit to SLV Package ChecklistProduct Documentation Online FrameSaver DSL 9783 User’s GuideInterface Feature Connection Cables Number Wiring and Cables You May NeedEthernet port Cable supplied for use in the U.SProvisioning Data Circuits in OpenLane Prior to Installing the RouterDSL 9783 Router Installing the RouterProcedure Ethernet COM Ethernet Port green Power-OnSystem OK green Alarm red Condition Status Status LEDsLED Symptom Action TroubleshootingUnplug the unit, unless instructed to do so by the service ProviderConfiguration Setup Main Menu Press Main Menu → ConfigurationMenu Navigation Main Menu → Easy Install Using the Easy Install FeatureEasy Install Screen Example Verifying that Self-Test PassedCompleting Setup From the NOC Configuring Snmp Trap Managers and Traps Procedure Setting Up for In-Band ManagementShow config Configuration → Virtual Router Ports → Dlci RecordsMain Menu → Status → Performance Statistics → Frame Relay Checking That Data is Being Received ProcedureVerifying the End-to-End Management Path Checking PVC Connections Provisioning the Router InterfaceCable Cables and ConnectorsPin Connector Similar to RJ48C Pin # Function Pin Ethernet Crossover Cable Function Pin # Pin # Function Pin Straight-Through ConnectionsEthernet Pin # Signal Direction Connecting an External ModemSpecification DSL Router Technical SpecificationsImportant Safety Instructions EMI Notices CE MarkingGovernment Requirements Trademarks Warranty, Sales, Service, and Training InformationDocument Feedback
Related manuals
Manual 166 pages 36.17 Kb Manual 233 pages 22.17 Kb