Paradyne 1754 manual Priority map configuration

1752 and 1754 SHDSL Router User’s Guide

	interface in its egress interface list.
User priority	The user priority to regenerated user-priority	0
	mapping for a bridge interface.
Transport	Name of attached transport.
Priority map	The mapping of user priority in the incoming
	frames to the regenerated user priority that would
	be used for traffic class mapping as well as set in
	the VLAN tag of the outgoing frame. How to
	configure is introduced in the following section.

Priority map configuration

Click on priority map for a specified bridge interface, and then the Priority Map for the bridge interface page is displayed. In this page, number of traffic classes, user priority to regenerated priority map and Regenerated Priority to Traffic Class Map are provided to configure. The procedure is shown as follows:

1.Number of traffic classes, as shown in the following figure, specifies the number of traffic classes supported by the bridge interface. It can be any value between 1 and 8.

2.User Priority to Regenerated Priority Map, as shown is the following figure, specifies the mapping of user priority in the incoming frames to the regenerated user priority that would be used for traffic class mapping as well as set in the VLAN tag of the outgoing frame.

The following table gives the range of values for each option which can be specified with this command and a default value.

Option	Description	Default value
Priority 0	The regenerated user-priority to which the user	0
	priority with value 0 in the incoming frame should
	be mapped.

68 June 2005 1752-A2-GB20-00