2.2.1.4 Example 4
SSP100EN (s0,b300,i3,wd8)
In example 4, the Enabler will configure the SSP-100 in socket 0 with a base address of 300H and IRQ 3 using a configuration memory window at segment D800.
2.2.1.5 Example 5
SSP100EN (i5,b340,s1)
In example 2, the Enabler will configure the SSP-100 in socket 1 with a base address of 340H and IRQ 5 using a configuration memory window at segment D000.
2.2.1.6 Example 6
SSP100EN (s0,b300,i5,r)
In example 6, the Enabler will release the configuration used by the SSP-100 in socket 0 using a configuration memory window at segment D000. The base address and IRQ parameters are ignored and may be omitted.
2.2.1.7 Example 7
SSP100EN (s1,r,wcc)
In example 7, the Enabler will release the configuration used by the SSP-100 in socket 1 using a configuration memory window at segment CC00.
2.2.1.8 Example 8
SSP100EN (s0,b300,i5,e3)
In Example 8, the Client Driver will attempt to configure an SSP-100 into socket 0 with a base address of 300H and IRQ 5. The COM 3 spot of the BIOS Equipment list will be occupied with the SSP-100. If the requested socket, base address or interrupt resources are not available, the SSP-100 will not be configured and no update of the equipment list will take place. If the requested spot in the BIOS equipment list is not available, but the requested socket, base address, and IRQ are available, the SSP-100 will be configured but an error message will appear stating that no update of the equipment list can take place.
2.2.1.9 Example 9
SSP-100 User’s Manual | 2-11 |