Quatech SSP-100 user manual

Page 33

6.Select a Basic Configuration that displays "No conflicts" in the bottom display region titled Conflicting Device List from the drop down list. Some applications may not be able to access ports higher than COM4. To use the SSP-100 PCMCIA serial ports with these applications you might be forced to remove other serial communications devices from your system.

7.Windows should have chosen an available Interrupt Request setting automatically when the I/O address range was configured by a Basic Configuration selection. This default Interrupt Request setting should not need changed as long as "No conflicts" is displayed in the bottom display region titled Conflicting Device List. If you are satisfied with Windows selection then skip the next step.

8.To modify the Interrupt Request setting click the resource name and click the Change Setting button. An Edit Resource window will open up. Inside this window click on the up/down arrows to the right of the Interrupt Request value. This scrolls you through all of the allowable resources for your hardware. Pay attention to the conflict information at the bottom of the window. Do not select a value that causes a conflict with any other installed hardware.

9.If any changes have been made to the SSP-100’s configuration the card will automatically be reconfigured to the new resources specified. Any time a PCMCIA card of this type is inserted Windows will attempt to configure the card at these resource settings. Click the Use Automatic Settings box to reset the SSP-100 card for automatic configuration.

SSP-100 User’s Manual

3-10

Image 33
Contents SSP-100 Page Page Warranty Information Declaration of Conformity Table of Contents Page Introduction This page intentionally left blank DOS / Windows 3.x Installation SSP-100 Client Driver for DOS Client Driver InstallationSsocket Command Line OptionsDevice = C\SSP-100\SSP100CL.SYS Device = C\SSP-100\SSP100CL.SYS b300,i5 Device = C\SSP-100\SSP100CL.SYS s0,b300,i5 s1,b340,i10 Generic Client Drivers Common ProblemsSSP-100 Enabler for DOS Option is not used SSP100EN SSP100EN s0,b300,i3,wd8 SSP100EN s0,a3 Memory Range Exclusion This Page Left Intentionally Blank SSP-100 User’s Manual Installing a SSP-100 Under Windows 95, 98, ME Windows 95, 98, 2000, ME, NT InstallationPage Windows 2000 New Hardware Wizard SSP-100 User’s Manual Viewing Resource Settings with Device Manager SSP-100 Resource Settings in WindowsWindows 95, 98,ME Device Manager SSP-100 User’s Manual Windows 2000 Device Manager Changing Resource Setting with Window 2000 Device Manager Windows 95,98,ME Resource Allocation SSP-100 User’s Manual Page Page Basic Configuration List Not Available Installing SSP-100 under Windows NT Page Page Page Windows CE Installing Quatech Pcmcia Cards under Windows CEPage Page OS/2 Installation Configuring With User Assigned Resources Configuring With System Assigned ResourcesDEVICE=C\SSP-100\SSP100.SYS 3,100,5 Advanced Configuration Topics Monitoring The Status Of Pcmcia Cards OS/2 Plug and Play GUI with properly configured SSP-100This Page Left Intentionally Blank SSP-100 Adapter Cable External ConnectionsThis page intentionally left blank Specifications SSP-100