Quatech ABDG-ET-DP501/IN5010 quick start Led

AirborneDirect™ Ethernet Adapter Quick Start Guide			Quatech, Inc.
	Step	Description
	Optional	Restarts the device. After the device as rebooted it will attempt
	Press Restart [Button]	to authenticate to the configured network. As long as the
		network is in range the wireless interface will connect.
		If the network is using DHCP then an IP address will be
		assigned to the WLAN interface and IP connectivity is possible
		over the WLAN network.
		If the network is using static IP addresses it will be necessary to
		configure the network interface, see the next step.

The web interface supports advanced configuration of the device through the additional pages available. Please refer to the User’s Manual for details.

Table 2 – IN5010 Indicator LED’s

LED	Color		Airborne Device State
POWER		Adapter is not powered.
		Adapter is powered.
POST		Adapter is not powered.
		Adapter failed Power On Self Test (POST) and is not configured for
		wireless communication.
		Adapter passed POST but is not configured for wireless network
		communication.
		Adapter passed post and is configured for wireless communication.
LINK		Adapter is not powered.
		(Periodic Blinking) Adapter is searching for a valid network (Access Point)
		that matches device’s configuration.
		Adapter has successfully associated with an Access Point.
COMM		If Power LED is also Off then Adapter is not powered.
		If Power LED is On then:
		∙	No TCP session from WLAN or Ethernet interface has been
			established.
		A TCP connection to the adapter has been established from the Wireless
		or Ethernet interfaces but no traffic has been detected.

940-0193-210 6 February 2011