Quatech ABDG-ET-DP501/IN5010 quick start DP500 Indicator LED’s

AirborneDirect™ Ethernet Adapter Quick Start Guide					Quatech, Inc.
Table 3 – DP500 Indicator LED’s
	LED	Color		Airborne Device State
	POWER		Adapter is not powered.
			Adapter failed Power On Self Test (POST) and is not configured for
			wireless communication.
			Adapter passed POST but is not configured for wireless network
			communication.
			Adapter passed post and is configured for wireless communication.
	LINK		Adapter is not powered.
			(Periodic Blinking) Adapter is searching for a valid network (Access Point)
			that matches device’s configuration.
			Adapter has successfully associated with an Access Point.
	COMM		If Power LED is also Off then Adapter is not powered.
			If Power LED is On then either:
			∙	A physical connection detected on Serial/Ethernet cable.
			∙	No TCP session from wireless interface has been established.
			No physical Serial/Ethernet connection has been detected.
			(Blinking – OFF/Red) A physical Serial/Ethernet connection has been
			detected and there is traffic across the interface. No TCP connection to
			the adapter has been established on the wireless interface.
			A TCP connection to the adapter from the wireless interface has been
			established but no physical connection on the Serial/Ethernet interface
			has been detected.
			(Blinking – Green/Orange) A physical Serial/Ethernet connection has
			been detected and there is Serial/Ethernet traffic across the interface. A
			TCP connection to the adapter has been established (On WLAN or
			Ethernet interface).
			A physical Serial/Ethernet connection has been detected. A TCP
			connection to the adapter has been established from the WLAN or
			Ethernet interface but no traffic has been detected.

940-0193-210 7 February 2011