Quatech DSC-300, DSC-200 user manual Windows NT

Page 24

9.The "New Hardware Found" dialog will repeat for each of the serial ports on the DSC-200/300 as each port is registered with Windows.

10.Installation is complete.

5.6 Windows NT

The Windows NT device driver is installed by running the SETUP program. Up to 256 serial ports are supported. There is a command line-based configuration utility which is used for adding PCI bus and ISA bus serial ports. Please refer to the documentation included with the device driver for full installation and configuration details.

Device drivers for Windows and OS/2 are also available for the DSC-200/300. The board can be used under DOS and other operating systems as well in many circumstances. The software described below can be obtained from the Quatech web site if it did not come with the board.

Quatech DSC-200/300 User's Manual

24

Image 24

Contents DSC-200/300 Warranty Information Page Declaration of Conformity Manufacturers Name RS-422 or RS-485 Signal Line Termination Using the New Hardware Found WizardAddress Map and Special Registers Base Address and Interrupt Level IRQPage General Information Features IND Option --- Surge Suppression UpgradeHardware Configuration Factory default signal termination settingsSignal Connections Full-duplex/Half-duplex OperationEnable Scratchpad Register SPAD, J13 Clock Rate and Optional RegistersForce High-Speed Uart Clock X2, X4, or X8, J10-J12 Clock multiplier jumper optionsHardware Installation Jumper/connector locationsChannel Address Range Enabling the Special Registers Interrupt Status RegisterOptions Register Bit Name DescriptionClock Rate Multiplier RR1 RR0Windows Configuration Windows MillenniumWindows Windows Windows Page Using the New Hardware Found Wizard Windows NT DOS and Other Operating Systems QTPCI.EXEQTPCI.EXE Basic Mode display QTPCI.EXE Expert Mode display OS/2 External Connections Jumper/Channel correspondenceRTS/CTS Handshake RclkXclk AUXIN/AUXOUT LoopbackHalf-Duplex/Full-Duplex Selection Half- or full-duplex selection Termination Resistors RS-422/485 Line termination resistance valuesDSC-200/300 connector definitions RS-422/485 Peripheral ConnectionPCI Resource Map INTA#10Specifications Troubleshooting Computer will not boot upDSC-200/300 Revision June