Quatech DSC-300, DSC-200 user manual Windows

Page 20

5.3 Windows 98

1.After inserting a DSC-200/300 for the first time, the "Add New Hardware Wizard will appear at start up. Click the "Next" button.

2.Select "Search for the best driver for you device". Click the "Next" button.

3.On the next dialog, select the "CD-ROM DRIVE" check box. Insert the Quatech COM CD (shipped with the device) into the CD-ROM drive.

Click the "Next" button.

Quatech DSC-200/300 User's Manual

20

Image 20

Contents DSC-200/300 Warranty Information Page Declaration of Conformity Manufacturers Name RS-422 or RS-485 Signal Line Termination Using the New Hardware Found WizardAddress Map and Special Registers Base Address and Interrupt Level IRQPage General Information Features IND Option --- Surge Suppression UpgradeHardware Configuration Factory default signal termination settingsSignal Connections Full-duplex/Half-duplex OperationEnable Scratchpad Register SPAD, J13 Clock Rate and Optional RegistersForce High-Speed Uart Clock X2, X4, or X8, J10-J12 Clock multiplier jumper optionsHardware Installation Jumper/connector locationsChannel Address Range Enabling the Special Registers Interrupt Status RegisterOptions Register Bit Name DescriptionClock Rate Multiplier RR1 RR0Windows Configuration Windows MillenniumWindows Windows Windows Page Using the New Hardware Found Wizard Windows NT DOS and Other Operating Systems QTPCI.EXEQTPCI.EXE Basic Mode display QTPCI.EXE Expert Mode display OS/2 External Connections Jumper/Channel correspondenceRTS/CTS Handshake RclkXclk AUXIN/AUXOUT LoopbackHalf-Duplex/Full-Duplex Selection Half- or full-duplex selection Termination Resistors RS-422/485 Line termination resistance valuesDSC-200/300 connector definitions RS-422/485 Peripheral ConnectionPCI Resource Map INTA#10Specifications Troubleshooting Computer will not boot upDSC-200/300 Revision June