Quatech DSC-200, DSC-300 user manual

Page 3

(c) 1998 - 2000, Quatech, Inc.

NOTICE

The information contained in this document cannot be reproduced in any form without the written consent of Quatech, Inc. Likewise, any software programs that might accompany this document can be used only in accordance with any license agreement(s) between the purchaser and Quatech, Inc. Quatech, Inc. reserves the right to change this documentation or the product to which it refers at any time and without notice.

The authors have taken due care in the preparation of this document and every attempt has been made to ensure its accuracy and completeness. In no event will Quatech, Inc. be liable for damages of any kind, incidental or consequential, in regard to or arising out of the performance or form of the materials presented in this document or any software programs that might accompany this document.

Quatech, Inc. encourages feedback about this document. Please send any written comments to the Technical Support department at the address listed on the cover page of this document.

DOS, Windows ME, Windows 2000, Windows 98, Windows 95, Windows NT are trademarks or registered trademarks of Microsoft Corporation. OS/2 is a registered trademark of IBM Corporation. All other trademarks or registered trademarks are property of their respective owners.

Image 3
Contents DSC-200/300 Warranty Information Page Declaration of Conformity Manufacturers Name Base Address and Interrupt Level IRQ RS-422 or RS-485 Signal Line TerminationUsing the New Hardware Found Wizard Address Map and Special RegistersPage General Information IND Option --- Surge Suppression Upgrade FeaturesFactory default signal termination settings Hardware ConfigurationFull-duplex/Half-duplex Operation Signal ConnectionsClock Rate and Optional Registers Enable Scratchpad Register SPAD, J13Clock multiplier jumper options Force High-Speed Uart Clock X2, X4, or X8, J10-J12Jumper/connector locations Hardware InstallationChannel Address Range Interrupt Status Register Enabling the Special RegistersBit Name Description Options RegisterRR1 RR0 Clock Rate MultiplierWindows Millennium Windows ConfigurationWindows Windows Windows Page Using the New Hardware Found Wizard Windows NT QTPCI.EXE DOS and Other Operating SystemsQTPCI.EXE Basic Mode display QTPCI.EXE Expert Mode display OS/2 Jumper/Channel correspondence External ConnectionsRclk RTS/CTS HandshakeAUXIN/AUXOUT Loopback XclkHalf-Duplex/Full-Duplex Selection Half- or full-duplex selection RS-422/485 Line termination resistance values Termination ResistorsRS-422/485 Peripheral Connection DSC-200/300 connector definitionsINTA# PCI Resource Map10Specifications Computer will not boot up TroubleshootingDSC-200/300 Revision June