Quatech DSC-200, DSC-300 user manual QTPCI.EXE Expert Mode display

Page 27

non-Quatech PCI devices in the system, including those devices integrated on the motherboard. In this example, the "Base addr 0" resource is reserved.

For users interested in even more details, PCI BIOS information can be displayed by pressing the "B" key. Pressing the "I" key displays the PCI interrupt routing table.

Quatech PCI Configuration Information Display Software

Version 1.00

Quatech PCI adapters detected

---------------------------------------------

DSC-200/300 Two-port RS-422/485 adapter

Vendor ID 0x135c, Device id			0x0050	found in slot 0x04 on bus 0x00
Device/function code = 0x98,			Revision ID = 0x01 (Hardware revision A1)
PCI Class Code = 0x070200			Communications controller, multiport serial
Subsystem Vendor ID 0x135c, Subsystem Id 0x0050
INTA# mapped to IRQ 11 (route 0x61)
Base addr	0 =	0xfc80	I/O	0X80 bytes allocated
Base addr	1 =	0xffa80	I/O	0X40 bytes allocated
_

Q - Quatech PCI adapters	M - Change to Basic Mode
N - Other PCI devices	B - PCI BIOS details
X - EXIT	I - Interrupt routing details

Figure 16 --- QTPCI.EXE Expert Mode display

Quatech DSC-200/300 User's Manual

27

Image 27

Contents DSC-200/300 Warranty Information Page Declaration of Conformity Manufacturers Name Base Address and Interrupt Level IRQ RS-422 or RS-485 Signal Line TerminationUsing the New Hardware Found Wizard Address Map and Special RegistersPage General Information IND Option --- Surge Suppression Upgrade FeaturesFactory default signal termination settings Hardware ConfigurationFull-duplex/Half-duplex Operation Signal ConnectionsClock Rate and Optional Registers Enable Scratchpad Register SPAD, J13Clock multiplier jumper options Force High-Speed Uart Clock X2, X4, or X8, J10-J12Jumper/connector locations Hardware InstallationChannel Address Range Interrupt Status Register Enabling the Special RegistersBit Name Description Options RegisterRR1 RR0 Clock Rate MultiplierWindows Millennium Windows ConfigurationWindows Windows Windows Page Using the New Hardware Found Wizard Windows NT QTPCI.EXE DOS and Other Operating SystemsQTPCI.EXE Basic Mode display QTPCI.EXE Expert Mode display OS/2 Jumper/Channel correspondence External ConnectionsRclk RTS/CTS HandshakeAUXIN/AUXOUT Loopback XclkHalf-Duplex/Full-Duplex Selection Half- or full-duplex selection RS-422/485 Line termination resistance values Termination ResistorsRS-422/485 Peripheral Connection DSC-200/300 connector definitionsINTA# PCI Resource Map10Specifications Computer will not boot up TroubleshootingDSC-200/300 Revision June