Quatech ES-100 user manual EC Council Directive 89/336/EEC, FCC Class B

Page 5

Compliances - Electromagnetic Emissions

EC - Council Directive 89/336/EEC

This equipment has been tested and found to comply with the limits of the following standards for a digital device:

￿EN50081-1 (EN55022, EN60555-2, EN60555-3)

￿EN50082-1 (IEC 801-2, IEC 801-3, IEC 801-4)

Type of Equipment:

Information Technology Equipment

Equipment Class:

Commercial, Residential, & Light Industrial

FCC - Class B

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation, If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

￿Reorient or relocate the receiving antenna.

￿Increase the separation between the equipment and receiver.

￿Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

￿Consult the dealer or an or an experienced radio/TV technician for help.

This equipment has been certified to comply with the limits for a Class B computing device, pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the equipment without the approval of the manufacturer could void the user's authority to operate this equipment.

ES-100

User's Manual

Quatech Inc., ES-100 Manual

Page 4 Page 6
Image 5
Page 4 Page 6
Contents ES-100 Page Warranty Information Page FCC Class B EC Council Directive 89/336/EECGeneral Information Port Address IRQ InstallationDiagram of ES-100D Addressing Ports Setting the addressExamination of a serial port base address Interrupt Status register Interrupt Level IRQInterrupt Sharing Interrupt Status Register contents This page intentionally left blank External Connections ES-100D connector definitions Channel Output ConfigurationES-100D output connectors Serial Port Functional Description Dlab Accessing the Serial Port registersInterrupt Identification Register Interrupt Enable RegisterInterrupt Identification Register bit definitions RXT0 Fifo Control Register 16550 onlyEPS PEN Parity Line Control RegisterModem Control Register bit definitions Modem Control RegisterLine Status Register bit definitions Line Status RegisterScratchpad Register Modem Status RegisterWhen the receiver Fifo and receiver interrupts are enabled Fifo Interrupt Mode Operation 16550 Uart onlyFifo polled mode operation 16550 Uart only Value Values % Baud Rate Selection16450 16550 optional SpecificationsComputer will not boot up TroubleshootingVersion March Quatech Inc, ES-100 Manual
Top Page Image Contents