Quatech ES-100 user manual Installation, Port Address IRQ

Page 7

2.INSTALLATION

If the default address and interrupt settings are sufficient, the ES-100D can be quickly installed and put to use. The factory defaults are listed in Figure 1.

PORT	ADDRESS	IRQ

Serial 1	300 hex	3

Serial 2	308 hex	3

Serial 3	310 hex	3

Serial 4	318 hex	3

Serial 5	320 hex	3
Serial 6	328 hex	3

Serial 7	330 hex	3

Serial 8	338 hex	3

Figure 1 --- Default address and IRQ settings for ES-100D

The output of the ES-100D is a 78-pin D-connector. A cable is provided to convert the D-78 into eight standard male D-25 connectors with all control signals provided to each port (RTS, DTR, CTS, DSR, DCD, and RI). See section V of this manual for connector details.

1.If the default settings are correct, skip to step 2, otherwise refer to sections III and IV of this document for detailed information on how to set the address and IRQ level.

2.Turn off the power of the computer system in which the ES-100D is to be installed.

3.Remove the system cover according to the instructions provided by the computer manufacturer.

4.Install the ES-100D in any vacant expansion slot. The board should be secured by installing the Option Retaining Bracket (ORB) screw.

5.Replace the system cover according to the instructions provided by the computer manufacturer.

Attach and secure the cable connectors to the desired equipment.

2	Quatech ES-100D User's Manual

Image 7

Contents ES-100 Page Warranty Information Page FCC Class B EC Council Directive 89/336/EECGeneral Information Port Address IRQ InstallationDiagram of ES-100D Addressing Ports Setting the addressExamination of a serial port base address Interrupt Sharing Interrupt Level IRQInterrupt Status register Interrupt Status Register contents This page intentionally left blank External Connections ES-100D connector definitions Channel Output ConfigurationES-100D output connectors Serial Port Functional Description Dlab Accessing the Serial Port registersInterrupt Identification Register Interrupt Enable RegisterInterrupt Identification Register bit definitions RXT0 Fifo Control Register 16550 onlyEPS PEN Parity Line Control RegisterModem Control Register bit definitions Modem Control RegisterLine Status Register bit definitions Line Status RegisterScratchpad Register Modem Status RegisterWhen the receiver Fifo and receiver interrupts are enabled Fifo Interrupt Mode Operation 16550 Uart onlyFifo polled mode operation 16550 Uart only Value Values % Baud Rate Selection16450 16550 optional SpecificationsComputer will not boot up TroubleshootingVersion March Quatech Inc, ES-100 Manual