Master Unit Settings

APPENDIX D

PATTON ELECTRONICS MODEL 1092A

CONTROL PORT PIN ASSIGNMENT

The 1092A control port is an 8 position connector, compliant with EIA/TIA-561.

Pin Function	RJ45 Pin No.
Ground	4
Receive data (to DTE)	5
Transmit data (from DTE)	6

APPENDIX E

PATTON ELECTRONICS MODEL 1092A

QUICK START GUIDE

1)To perform a hardware reset, turn the power off and set configuration switch (S1-6 and 7 “OFF").

2)Turn on the power for 5 or 10 seconds. Turn the power OFF and re-configure the model 1092A using the following configuration. One unit must be set as Master the other unit as Slave.

S1-1 "ON"

S1-2 "OFF"

S1-3 "ON"

S1-4 and 5 "OFF"

S1-6 and 7 "ON"

S1-8 "ON"

S2-1, 2, and 3 "OFF"

S2-4 "ON" (4-wire operation) "OFF" (2-wire operation)

S2-5 "OFF"

S2-6, 7 and 8 "ON"

SLAVE UNIT SETTINGS

S1-1 "ON"

S1-2 "OFF"

S1-3 "ON"

S1-4 and 5 "OFF"

S1-6 "ON"

S1-7 "OFF"

S1-8 "ON"

Switch S2 settings are the same as the MASTER UNIT.

3)Connect the twisted pair circuit between the model 1092A's, turn on the power, after 10 to 15 seconds the NS (no signal)- LED will go off and the CD (carrier detect) LED will turn GREEN.

4)Perform a LOCAL LINE LOOP-BACK test using the 511/511E test switch (See section 5.3.1).

5)Approximately 45 seconds after the units link up, perform a REMOTE DIGITAL LOOP-BACK test using the 511/511E test switch. (See section 5.3.2).

Patton Electronics Company