50CHAPTER 6: CONFIGURING REDUNDANT SERVER LOAD BALANCING
7Select the serial number of the peer device. In this case, the peer device is the second Server Load Balancer.
8Click Next. The Getting Started - IP Settings page appears.
If you change these settings, you may lose IP connectivity to the Web interface upon completion of this wizard. If this occurs, you will need to reconnect to the Server Load Balancer using the new IP address.
9The IP Address, Subnet Mask and Default Router fields are completed. These is the information you assigned to the Server Load Balancer during the CLI setup.
10Enter 10.20.30.56 in the Device B IP Address field.
This is the IP address assigned to the second Server Load Balancer.
11Click Next. The Getting Started - Network Address Translation page appears.
If you are using private IP subnets for your server or cache subnets and want the servers or caches to be able to initiate connections to the outside, check NAT Enabled for Server and Cache Subnets. If NAT is enabled, packets initiated by the servers and the caches need to be given an IP address on the primary IP subnet. This address is the alias address.
12Click Next. The Getting Started - Password page appears.
CAUTION: The Server Load Balancer does not provide a way to recover a lost password. If you choose to assign a new password, it is suggested you keep note of it in a safe place. If you forget your password, you will be locked out of the unit. If you change the password during the CLI Server Load Balancer setup, this is the password you should use, and not the blank default login password. For Technical Support information, see Appendix C.
13Click Next. The Getting Started - Advanced page appears
14Click Continue with Advanced Settings and click Next.
15Select
16Click Finish. The parameters you have entered are ready to be applied.
You are now ready to configure the load balancing services. See Chapter 8 Configuring for Load Balancing.