76APPENDIX A: SAFETY INFORMATION
Important Safety | ■ | Installation and removal of the unit must be carried out by qualified |
Information |
| personnel only. |
| ■ If installing the Server Load Balancer in a stack with SuperStack 3 units | |
|
| that are narrower than the Server Load Balancer, the Server Load |
|
| Balancer unit must be installed below the narrower units. |
| ■ Connect the unit to an earthed power supply to ensure compliance | |
|
| with safety standards. |
| ■ | Power Cord Set: |
|
| This must be approved for the country where it is used: |
U.S.A. and Canada
United Kingdom only
Europe only:
■The cord set must be
■The minimum specification for the flexible cord is: No. 18 AWG
Type SV or SJ
■The cord set must have a rated current capacity of at least 10A.
■The attachment plug must be an
■The supply plug must comply with BS1363
■The mains cord must be <HAR> or <BASEC> marked and be of type H03VVF3GO.75 (minimum).
■The supply plug must comply with CEE 7/7 (“SCHUKO”).
■The mains cord must be <HAR> or <BASEC> marked and be of type H03VVF3GO.75 (minimum).
Denmark | ■ | The supply plug must comply with section |
|
| standard |
Switzerland | ■ | The supply plug must comply with SEV/ASE 1011. |
■The appliance coupler (the connector to the unit and not the wall plug) must have a configuration for mating with an EN60320/IEC320 appliance inlet.
■The socket outlet must be near to the unit and easily accessible. You can only remove power from the unit by disconnecting the power cord from the outlet.