HP SuperStack 3 Load Balancer Appliance manual Important Safety Information

Important Safety Information 77

■This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC 950. The conditions are only maintained if the equipment to which it is connected also operates under SELV conditions.

■France and Peru only:

This unit cannot be powered from IT† supplies. If your supplies are of IT type, this unit must be powered by 230V (2P+T) via an isolation transformer ratio 1:1, with the secondary connection point labelled Neutral, connected directly to earth (ground).

†Impédance à la terre.

■The switch should only be used in a rack if it is mounted on runners, a shelf, or a tray to support the weight. The rack mount kits alone are not sufficient to support the weight of the switch. The rack mount kits must not be used to suspend the switch from under a table or desk, or attach it to a wall.

■

■

If you are connecting the Server Load Balancer to a Type 3 Power Module, read the Safety Information section in the Type 3 Power Module User Guide.

WARNING: Fiber Optic ports - Optical Safety

■Never look at the transmit laser while it is powered-up. Never look directly at the fiber TX port and fiber cable ends when they are powered-up.

■Use of controls or adjustments of performance or procedures other than those specified herein may result in hazardous laser emissions.