|
| The Server Load Balancer is 1.5U and fits in most standard | ||||||
|
| However, if you are connecting the Server Load Balancer to a ARPS Type 3 | ||||||
|
| power module, a runner, shelf or tray is recommended to support the | ||||||
|
| additional weight. You will need to allow a 2U space within the rack for | ||||||
|
| each Server Load Balancer. | ||||||
|
| WARNING: The | ||||||
|
| weight of the Server Load Balancer when attached to an ARPS power | ||||||
|
| module. It is recommended that you use a runner, shelf or tray to support | ||||||
|
| the total weight. The rack mount kits must not be used to suspend the | ||||||
|
| Server Load Balancer from under a table or desk, or attach it to a wall. | ||||||
|
| CAUTION: You must use a full depth shelf or support that will not | ||||||
|
| obstruct the air flow through the side panels of the Server Load Balancer. | ||||||
|
| CAUTION: Disconnect all cables from the Server Load Balancer before | ||||||
|
| continuing. Remove all self adhesive pads from the underside of the | ||||||
|
| Server Load Balancer if they have been fitted. | ||||||
|
| To | ||||||
| 1 Place the unit the right way up on a hard flat surface, with the front | |||||||
|
| facing towards you. | ||||||
| 2 Locate a mounting bracket over the mounting holes on one side of the | |||||||
|
| unit, as shown in Figure 3. | ||||||
|
| Figure 3 Fitting a bracket for | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
