Patton electronic 1068 user manual Operation, Power UP, Front Panel LED Status Monitors

5.0 OPERATION

Once the VLINK modems are properly installed, they should operate transparently. No user settings required. This section describes reading the LED status monitors.

5.1 POWER UP

Before applying power to the VLINK modem, please review section 3.6, “Connecting Power” on page 12 to verify that the unit is connected to the

appropriate power source.

There are no user-serviceable parts in the VLINK modem.Fuse replacement should only be performed by qualified service personnel. Contact Patton Elec- tronics Technical support at (301) 975-1007 for more information.

WARNING

5.2 FRONT PANEL LED STATUS MONITORS

The VLINK modem features nine front panel LEDs (five on the rack card) that monitor power, the Ethernet signals, and the VDSL connection. Figure 11 (standalone version) and Figure 12 on page 19 (rack card ver- sion) show the front panel LEDs. Table 5 on page 18 describes the LED functions for the standalone model, Table 6 on page 19 describes the LED functions for the rack card.

	Ethernet
	100M LED
	Ethernet
	FDx LED
	Ethernet
	Collision LED
Power	Ethernet
LED	Link LED
	VLINK
	QOL LED

VLINK

Link LED

Figure 11. VLINK modem standalone unit front panel

17