Patton electronic 1068 user manual Warranty Information, Radio and TV Interference FCC Part

Page 4

1.0 WARRANTY INFORMATION

Patton Electronics warrants all VLINK modem components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of the shipment.

This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modification. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequential damages arising from the use of or inability to use this product. Patton Electronics spe- cifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user.

Note Conformity documents of all Patton products can be viewed online at www.patton.com under the appropriate product page.

1.1 RADIO AND TV INTERFERENCE (FCC PART 15)

This equipment generates and uses radio frequency energy, and if not installed and used properly—that is, in strict accordance with the manu- facturer's instructions—may cause interference to radio and television reception. This equipment has been tested and found to comply with the limits for a Class A computing device in accordance with the specifica- tions in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection from such interference in a commercial installa- tion. However, there is no guarantee that interference will not occur in a particular installation. If the equipment causes interference to radio or television reception, which can be determined by disconnecting the cables, try to correct the interference by one or more of the following measures: moving the computing equipment away from the receiver, re- orienting the receiving antenna, and/or plugging the receiving equipment into a different AC outlet (such that the computing equipment and receiver are on different branches).

1.2 CE DECLARATION OF CONFORMITY

We certify that the apparatus identified in this document conforms to the requirements of Council Directive 1999/5/EC on the approximation of the laws of the member states relating to Radio and Telecommunication Ter- minal Equipment and the mutual recognition of their conformity.

4

Image 4
Contents User Manual Contents Distance Chart, Based on 24 AWG 0.5 MM Radio and TV Interference FCC Part Warranty InformationCE Declaration of Conformity Service Accessible, and protected by a circuit breakerTel +1 301 Email support@patton.com Feet 3 meters of the device, shall be easilyFeatures General InformationDescription Typical applicationStandalone Unit Installation InstallationVlink Data & Voice 1068 Rack Card Installation 1068RCConnecting the TWISTED-PAIR Line Interface Vlink modem RJ-45 twisted pair line interfaceConnecting the 10/100BASE-T Ethernet Interface Vlink modem 10/100Base-T RJ-45 Connector PinoutConnecting the POTS/ISDN Line Connecting PowerConfiguration Configuring the Hardware DIP SwitchesSwitch toggle Configuring DIP Switch S1 Switch S1-1 Ethernet Auto SenseS1-1 Setting Switches S1-2 and S1-4 Data RateS1-2 S1-3 S1-4 Asymmetric Line Rates DS/US S1-5 S1-6 S1-7 S1-8 Reserved for future useOperation Power UPFront Panel LED Status Monitors Description LEDLED is solid yellow and the Vlink Link LED is Off QOL LED Status Indicators Power SupplyAppendix a LAN ConnectionDimensions Temperature RangeHumidity Appendix B Patton Model # DescriptionPower Cords Appendix C 10/100BASE-T InterfaceVdsl Interface POTS/ISDN InterfaceSymm Line Rate Distance in feet km Appendix DAsymm Line Rate DS/US Distance in feet km Page Copyright Patton Electronics Company All Rights Reserved