Patton electronic 2715, 275, Network Hardware user manual Appendix C, DB9F

Page 19

	APPENDIX C		APPENDIX D
PATTON MODEL 2715			PATTON MODEL 2715
FACTORY REPLACEMENT PARTS			INTERFACE PIN ASSIGNMENTS
	AND ACCESSORIES
Patton Model #	Description		RJ-48C E1 Network Interface
Patton Model #	Description		(RJ-48S Female Modular Jack)
2715/CM/UI	V.35 to E1 Converter (V.35 M/34 Male,
	UI)
10 - 09F	6 Foot Control Port Cable, 25 mm to	Pin #	Signal
10 - 09F	6 Foot Control Port Cable, 25 mm to	1	RX Data (RING)
	DB9F	2	RX Data (TIP)
08055DCUI	Universal Input Power Supply	4	TX Data (RING)
08055DCUI	Universal Input Power Supply	5	TX Data (TIP)
10-CISCO-V35FT-1	Cable, V35 (M/34) Female To LFH60
	Male
07M2715	User Manual

Image 19

Contents User Manual Warranty Statement Patton Model Table of ContentsGeneral Information Tel 301 Email support@patton.com Service InformationRadio and TV Interference CE and Telecommunication Approvals2715 as the Interface between the Telco and CPE FeaturesGeneral Product Description Supported ApplicationsSwitch SW1 Line Coding ConfigurationDIP Switch Configuration Switch SET Summary TableClock Modes MULTIFRAMEG.704CRC-4 MF Unframed G.703 SW3 SW4Software Configuration Helpful Hints Introduction to Main MenuLine Format G.703 default Options G.703, G.704 System ConfigurationLine Coding HDB3 default Default Config Source Switch default Options EEPROM, Switch CRC-4 Setting Disabled default Options Enabled, DisabledCAS MF Setting Disabled default Options Enabled, Disabled 54 Loops Enabled default Options Enabled, DisabledLocal Loop Idle default System DiagnosticsSpacebar Remote Loop Idle defaultTest Pattern Idle default Options Idle or Sending Error Insertion Off default Options On, OffUnit Options Current DIP Switch SettingsPassword NI StatusNetwork Interface Connection DTE Interface ConnectionRXD Power ConnectionLED Descriptions TXDERR Loop V.54 & Telco DiagnosticsLOS ALM2047 BIT Error Rate V.52 DiagnosticsError Insertion to on 511Patton Model Cable Recommendations SpecificationsDB9F Appendix CJumper Position for Power via Pin KK Connector, Terminal InterfacePatton Model Power Supply Interface Jumper Position for Power via DC Power Jack defaultCopyright Patton Electronics Company All Rights Reserved

APPENDIX C

DB9F