Patton electronic 275, 2715 user manual Copyright Patton Electronics Company All Rights Reserved

Page 21

Copyright © 2006

Patton Electronics Company

All Rights Reserved.

Image 21

Contents User Manual Patton Model Table of Contents Warranty StatementGeneral Information Radio and TV Interference Service InformationCE and Telecommunication Approvals Tel 301 Email support@patton.comGeneral Product Description FeaturesSupported Applications 2715 as the Interface between the Telco and CPEDIP Switch Configuration ConfigurationSwitch SET Summary Table Switch SW1 Line CodingCRC-4 MF MULTIFRAMEG.704Unframed G.703 SW3 SW4 Clock ModesSoftware Configuration Helpful Hints Introduction to Main MenuSystem Configuration Line Format G.703 default Options G.703, G.704Line Coding HDB3 default CAS MF Setting Disabled default Options Enabled, Disabled CRC-4 Setting Disabled default Options Enabled, Disabled54 Loops Enabled default Options Enabled, Disabled Default Config Source Switch default Options EEPROM, SwitchLocal Loop Idle default System DiagnosticsTest Pattern Idle default Options Idle or Sending Remote Loop Idle defaultError Insertion Off default Options On, Off SpacebarPassword Current DIP Switch SettingsNI Status Unit OptionsNetwork Interface Connection DTE Interface ConnectionLED Descriptions Power ConnectionTXD RXDLOS Loop V.54 & Telco DiagnosticsALM ERRError Insertion to on BIT Error Rate V.52 Diagnostics511 2047Patton Model Cable Recommendations SpecificationsDB9F Appendix CPatton Model Power Supply Interface Connector, Terminal InterfaceJumper Position for Power via DC Power Jack default Jumper Position for Power via Pin KKCopyright Patton Electronics Company All Rights Reserved