Patton electronic manual Getting started with SmartNode 4400 Series, Chapter contents

Page 34

Chapter 4 Getting started with the
SmartNode 4400 Series
Chapter contents
Introduction	35
1. Configure IP address	36
Factory-default IP settings	36
Connect to the RS-232 console port	37
Login	38
Changing the WAN IP address	38
2. Connecting the SmartNode to the network	39
3. Loading the configuration (optional)	39
Bootloader	40
Start Bootloader	40
Start-up with factory configuration	41
Load a new application image (SmartWare) via TFTP	41
Load a new application image (SmartWare) via the serial link	43
Additional information	43

34

Image 34

Contents SmartNode Mailsupport@patton.com Summary Table of Contents Table of Contents Getting started with the SmartNode 4400 Series Port pin-outs List of Figures List of Tables Audience PrecautionsAbout this guide StructureAbout this guide Safety when working with electricity Sonnel. Opening the SmartNode case will void the warrantyPreventing Electrostatic Discharge Damage General observationsTypographical conventions used in this document General conventionsChapter contents General informationSmartNode 4400 Series overview Model SN4432 IpChannel BankSmartNode 4400 Series detailed description Power Solid Green Power is applied SmartNode 4400 Series front panelSmartNode 4400 Series rear panels Telco ports Console port Ethernet portsReset button behavior Applications overview Introduction SmartNode 4400 Series applicationsBulk analog line extensions Legacy MTU/MDU migration to VoIP based networksHardware installation Planning the installation Installation checklist Site logNetwork information AC Power MainsConﬁguration tools Location and mounting requirements Installing the IpChannel BankIpChannel Bank chassis installation Unpacking the Model SN4400 series IpChannel BankConnecting cables Connecting the FXS portsModel SN4400 Ethernet port Connecting power Grounding the Model SN4400-AC and DC unitsInstalling the power cables-AC units Installing the power cables-DC units DC connector, -DC and +DC input view Getting started with SmartNode 4400 Series Connecting the SmartNode to your laptop PC Factory-default IP settings Conﬁgure IP addressConnecting to the RS-232 Console port Connect to the RS-232 console portLogin Changing the WAN IP addressConnecting the SmartNode to the network Loading the conﬁguration optionalBootloader Start BootloaderStart-up with factory conﬁguration Load a new application image SmartWare via TftpCopy tftp//tftpserveraddress/server path/b1 flash Additional information Load a new application image SmartWare via the serial linkContacting Patton for assistance Warranty coverage Contact informationOut-of-warranty service RMA numbersAppendix a Compliance information CE Declaration of Conformity Safety complianceCompliance Authorized European RepresentativeAppendix B Speciﬁcations Ethernet interface Voice processing signaling dependentVoice connectivity FXS Console portVoice signaling Fax and modem supportManagement IP servicesVoice routing-session router Operating environmentPower supply DimensionsWeight and power dissipation SystemIdentiﬁcation of the SmartNode devices via Snmp SmartNode Model SysObjectIDAppendix C Port pin-outs Ethernet 10Base-T and 100Base-T port EIA-561 RJ-45 8-pin portBlue Purple Blue Band marked color-codes for the 50-pin RJ-21X connector Violet Appendix D Factory Conﬁguration Factory Configuration Appendix E End user license agreement End User License Agreement Termination Other licensesAppendix F Installation checklist Task Veriﬁed by Date Appendix G Accessories Description Part Number