Teac A-H300mkIII owner manual For U.S.A, Left and Right Panels

Page 2

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER- SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

IMPORTANT SAFETY INSTRUCTIONS

1)Read these instructions.

2)Keep these instructions.

3)Heed all warnings.

4)Follow all instructions.

5)Do not use this apparatus near water.

6)Clean only with dry cloth.

7)Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8)Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9)Do not defeat the safety purpose of the polarized or grounding-

type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10)Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11)Only use attachments/accessories specified by the manufacturer.

12)Use only with the cart, stand, tripod, bracket,

or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13) Unplug this apparatus during lightning storms or when unused for long periods of time.

14)Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

<Do not expose this apparatus to drips or splashes.

<Do not place any objects filled with liquids, such as vases, on the apparatus.

<Do not install this apparatus in a confined space such as a book case or similar unit.

<The apparatus draws nominal non-operating power from the AC outlet with its POWER switch in the standby position.

<The apparatus should be located close enough to the AC outlet so that you can easily grasp the power cord plug at any time.

<An apparatus with Class ! construction shall be connected to an AC outlet with a protective grounding connection.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

<DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO EXPOSE THE ELECTRONICS. NO USER SERVICEABLE PARTS ARE WITHIN!

<IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT, CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE PRODUCT UNTIL IT HAS BEEN REPAIRED.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the equipment and/or the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications to this equipments not expressly approved by TEAC CORPORATION for compliance will void the user’s warranty.

CAUTION Regarding Placement

To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal to, or greater than, shown below.

Left and Right Panels

:

5 cm

Rear Panel

:

5 cm

Top Panel

: 20 cm

2

Image 2
Contents H300mk# For U.S.A Left and Right PanelsReciclaje de su producto viejo Disposal of your old applianceMise au rebut de votre ancien appareil Before Use ContentsSpecificatioins System Connection Remote Control UnitBattery Installation Reference 300mkIIIConnection How to connect AC Outlet unswitchedAC Power Cord Speaker TerminalsNames of Each Control Buttons for the operation of Teac PD-H300mkIIICD FL Dimmer Remote SensorStandby Numeric buttonsBasic Operation Press the Power switchPress the STANDBY/ON switch to turn the unit on RecordingDubbing TroubleshootingMaintenance Avant utilisation SommaireSpécifications Mise en place des piles Boîtier de télécommandeRaccordement du système Référence 300mkIIIPlatine tourne-disque Platine cassette R-H300mkII RaccordementsSyntoniseur T-H300mkIII Lecteur de CD PD-H300mkIII EnceintesEmbase Secteur non commutée Bornes EnceintesPrises Audio IN/OUT Cordon SecteurNom de chaque commande Touches numériques Capteur de télécommandeTouches pour commander le Teac PD-H300mkIIICD FL Dimmer Enregistrement Pressez l’interrupteur PowerFonctions de base Entretien CopieDépannage Antes de comenzar IndiceEspecificaciones Instalación de las pilas Mando a distanciaConexión del sistema Tocadiscos Pletina de cassette R-H300mkII ConexiónSintonizador T-H300mkIII Reproductor de CD PD-H300mkIII AltavocesConectores Audio IN/OUT Signal GND tierra de señalTerminales de altavoz Toma de alimentación no conmutadaNombres de los controles Botones numéricos Sensor remotoBotones de control de la unidad Teac PD-H300mkIII FL Dimmer ObservaciónGrabación Pulse el interruptor PowerFuncionamiento básico Pulse el interruptor STANDBY/ON para encender la unidadMantenimiento Solución de problemasCopia Teac Corporation