ASpeaker Terminals
Caution:
To avoid damaging the speakers with a sudden
Check the impedance of your speakers. Connect speaker with an impedance of 6 to 16 ohms.
The black speaker terminals are _ (negative).
Generally, the + side of the speaker cable is marked to make it distinguishable from the _ side of the cable. Connect this marked side to the + terminal and the unmarked side to the black _ terminal.
Prepare the speaker cables for connection by stripping off approximately 10 mm or less of the outer insulation. (Removing too much insulation may lead to a short circuit if the bared wired should come in contact with each other.) Twist the strands of the stripped wires tightly together:
Caution:
The metal portions of the two separate wires should not touch or an electrical short can occur. Shorted wires can create a fire hazard or induce a failure in your equipment.
How to connect:
1.Turn the terminal cap counterclockwise to loosen it. The speaker terminal caps cannot be fully removed from the base.
2.Insert the wire into the terminal fully and turn the terminal cap clockwise to securely connect it:
Make sure none of the wire insulation is under the terminal, only the bare, stripped wire.
3. Make sure it is fastened firmly by pulling the cable lightly.
BAUDIO IN/OUT jacks
Analog
Make sure to connect :
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
CSIGNAL GND
Connect the ground lead of the turntable to this terminal.
<This is not a safety earth.
DAC OUTLET (unswitched)
Even when the unit is off, this outlet is active as long as the power cord is connected to an AC outlet.
Caution:
Make sure that the total power consumption of all equipment connected to the outlet(s) does not exceed 100 watts (or 500mA).
EAC Power Cord
After all other connections have been completed, connect the plug to the AC wall socket.
Be sure to connect the power cord to an AC outlet which supplies the correct voltage.
Hold the power plug when plugging or unplugging the power cord.
ENGLISH
7