Polycom 1725-36033-001 manual Phones per Access Point, Rate

Page 27

Configuring the SpectraLink 8000 SVP Server

SVP-II Mode

Defaults to SpectraLink IP for an IP environment. Press Enter to select and the screen is immediately redrawn with additional options for the IP environment.

The following options must be configured:

Phones per Access Point

AP specifications are detailed in the Configuration Notes for each brand and type. Refer to these notes when entering the number of simultaneous calls supported for your type.

802.11 Rate

Select 1MB/2MB to limit the transmission rate between the wireless telephones and APs. Select Automatic to allow the wireless telephone to determine its rate (up to 11 Mb/s).

PN: 1725-36033-001_C.doc

27

Image 27

Contents Administration Guide Trademark Information About This Document Polycom Model NumbersRelated Documents Icons and Conventions Customer SupportContents Index47H Software MaintenanceSafety Notices Swapping/Adding/Deleting SVP ServersSpectraLink 8000 SVP Server Overview SpectraLink Voice Priority SVP Quality of ServiceSpectraLink 8000 SVP Server Models Timing FunctionMultiple SVP Servers Registration Server identification SVP Server availabilityMultiple SVP Server Capacities SpectraLink SVP010 and SVP020 Server capacitySpectraLink SVP100 Server capacity SpectraLink 8000 SVP Server Overview SpectraLink 8000 SVP Server Administration Guide for SIP PBX System DiagramRouter Access pointsEthernet switch System ComponentsAdministrative computer SpectraLink 8000 SVP ServerTftp server LEDs Front Panel of the SVP ServerRequired Materials Installing the SpectraLink 8000 SVP ServerInstall the SVP Server Locate the SVP ServerMount the SVP Server on a rack Mount the SVP Server to a wall Grounding instructions SafetyConnect SVP Server to LAN Connect powerConfiguring the SpectraLink 8000 SVP Server Connecting to the SVP ServerConnect via the serial port NetLink SVP-II System Menu Connecting via telnetNetwork Configuration Hostname IP AddressDNS Server and DNS Domain Default GatewaySubnet Mask SVP-II Tftp Download MasterSVP Server Configuration Disable Telnet serviceSyslog Server Rate Phones per Access PointEthernet link Enable H.323 GatekeeperMaintenance Lock First Alias IP Address/Last Alias IP AddressReset all SVP Servers Inactivity Timeout minQoS Configuration Reset SystemDscp Tag QoS ConfigurationDefault value as shown in the table below will be used Change Password Adding an SVP Server Swapping/Adding/Deleting SVP ServersSVP Server Failure Software Updates Software MaintenancePage Troubleshooting via System Status Menu Alarm Text Action Error StatusNetwork Status Bytes bytes transmitted packets packets transmitted Software Version Name Major Version Filename Number Important Safety Information Safety NoticesPage Index