Polycom 1725-36033-001 manual NetLink SVP-II System Menu, Connecting via telnet

Page 22

SpectraLink 8000 SVP Server: Administration Guide for SIP

Connecting via telnet

Telnet can only be used after the SVP Server’s IP address is configured.

The telnet method of connection is used for routine maintenance of the SpectraLink Server for both local and remote administration, depending on your network.

To connect via telnet, run a telnet session to the IP address of the SVP Server. Once you connect and log in, the NetLink SVP-II System menu displays.

The NetLink SVP-II System Menu

The main menu displays as shown here:

System Status

Menu for viewing error messages, status of operation and software code version.

SVP-II Configuration

Allows you to set the mode and reset the system.

22	PN: 1725-36033-001_C.doc

Image 22

Contents Administration Guide Trademark Information Polycom Model Numbers About This DocumentRelated Documents Customer Support Icons and ConventionsContents Swapping/Adding/Deleting SVP Servers Software MaintenanceSafety Notices Index47HSpectraLink Voice Priority SVP Quality of Service SpectraLink 8000 SVP Server OverviewTiming Function SpectraLink 8000 SVP Server ModelsMultiple SVP Servers SVP Server availability Registration Server identificationSpectraLink SVP010 and SVP020 Server capacity Multiple SVP Server CapacitiesSpectraLink SVP100 Server capacity SpectraLink 8000 SVP Server Overview SpectraLink 8000 SVP Server Administration Guide for SIP System Diagram PBXSystem Components Access pointsEthernet switch RouterSpectraLink 8000 SVP Server Administrative computerTftp server Front Panel of the SVP Server LEDsInstalling the SpectraLink 8000 SVP Server Required MaterialsLocate the SVP Server Install the SVP ServerMount the SVP Server on a rack Grounding instructions Safety Mount the SVP Server to a wallConnect power Connect SVP Server to LANConnecting to the SVP Server Configuring the SpectraLink 8000 SVP ServerConnect via the serial port Connecting via telnet NetLink SVP-II System MenuNetwork Configuration IP Address HostnameSVP-II Tftp Download Master Default GatewaySubnet Mask DNS Server and DNS DomainDisable Telnet service SVP Server ConfigurationSyslog Server Phones per Access Point RateFirst Alias IP Address/Last Alias IP Address Enable H.323 GatekeeperMaintenance Lock Ethernet linkReset System Inactivity Timeout minQoS Configuration Reset all SVP ServersQoS Configuration Dscp TagDefault value as shown in the table below will be used Change Password Swapping/Adding/Deleting SVP Servers Adding an SVP ServerSVP Server Failure Software Maintenance Software UpdatesPage Troubleshooting via System Status Menu Error Status Alarm Text ActionNetwork Status Bytes bytes transmitted packets packets transmitted Software Version Name Major Version Filename Number Safety Notices Important Safety InformationPage Index