INSTALLATION
4)Light the pilot and turn the valve to "ON" position.
5)The pressure check should be carried out with the unit burning and the setting should be within the limits specifi ed on the safety label.
6)When fi nished reading manometer, turn off the gas valve, disconnect the hose and tighten the screw (clockwise) with a 1/8" fl at screwdriver. Note: Screw should be snug, but do not over tighten.
S.I.T. VALVE DESCRIPTION
1)Gas on/off knob
2)Manual high/low adjustment
3)Pilot Adjustment
4)Thermocouple Connection - option
5)Outlet Pressure Tap
6)Inlet Pressure Tap
7)Pilot Outlet
8)Main Gas Outlet
9)Alternative TC Connection Point
OPTIONAL
BRICK PANELS
1)Undo the bottom 2 door latches and open and remove glass door. Remove logs.
Note: The logs must not be in the unit.
2)Insert the back brick panel fi rst by carefully slipping it between the back wall of the fi rebox and the rear log bracket.
3)Put the side panels in next. Slide them in from the front and push them fl at up against the wall. Be very careful not to scratch them on the fi rebox hardware.
4)Install the 2 brick retaining clips, one on each side.
LOG SET
INSTALLATION
Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.
The gas log kit (Part #
a)
b)
c)
d)
e)
f)
g)
h) | Embers | |
i) | Vermiculite |
The "02" refer numbers (i.e.
molded into the rear of each log.
NOTE: If you will be installing the optional Brick Panels, install the Brick Panels prior to installing the logs.
1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.
2)Sprinkle the vermiculite around the fi rebox base.
Vermiculite | Vermiculite | Vermiculite |
3)Place the Log
Regency® | 21 |