Regency Wraps P36-NG4, P36-LPG4 manual Conversion Kit #513-968from NG to LPG

INSTALLATION

Conversion Kit #513-968 from NG to LPG

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!

Conversion Kit Contains:

Qty.	Part #	Description
1	910-037	LPG Injector
		(Pilot Orifi ce)

1904-390 Burner Orifi ce #52

1918-590 Decal "Converted to LPG"

1908-528 Red "LPG" label

1904-529 5/32" Allen Key

1918-546 Instruction Sheet

8)Remove burner orifi ce with a 1/2" wrench. Use another wrench to hold on to the elbow behind the orifi ce. Discard orifi ce.

WARNING!

Do not over tighten the screw. Recommended to

grip the wrench by the short side.

16)Verify that if the conversion is from NG to LPG, the screw must be re-assembled with the red o-ring visible (Fig. 5).

1)	Shut off the gas supply.
2)	Remove the louvers (and bay door if it is
	installed).
3)	Open the fl ush door and remove the door.
4)	Remove the logs and embers (if used).

Burner Orifi ce

9)Reinstall new burner orifi ce LPG stamped #52 and tighten.

10)Turn control knob to the “OFF” position.

Red o-ring visible

Fig.5

LPG Configuration

5) Remove the 2 screws holding the Burner

Assembly to the fi rebox base. Push the

Burner Assembly to the left and lift out.

Remove the 2 screws, push Burner Assembly

to the left and lift out.

6)Pull off the pilot cap to expose the pilot orifi ce.

7)Unscrew the pilot orifi ce with the allen key; then replace with the LPG pilot orifi ce and the pilot cap, provided in the kit.

11) Remove the black protection cap by hand from the hi-low knob (Fig.1).

Fig. 1

12)Insert a 5/32” or 4mmAllen wrench into the hexagonal key-way of the screw (Fig. 2), rotate it counter- clockwiseuntilitisfreeand extract it.

Fig.2

13)Check that the screw is clean and if necessary remove dirt.

14)Flip the screw (Fig. 3).

Fig.3

15)Using the Allen wrench as

shown in Fig.4, rotate the screw clockwise until snug, do not overtighten.

17)Re-assemble the black protection cap (Fig. 6).

18)Reverse step 2).

Fig. 6

WARNING!

Also check that the pilot and main burner injectors are appropriate for the gas type.

19)Attach clear label "This unit has been converted to LPG" near or on the serial

# decal.

20)Replace yellow "NG" label with red "LPG" label.

21)Check for gas leaks.

22)Check inlet and outlet pressures.

23)Check operation of fl ame control.

24)Check for proper fl ame appearance and glow on logs.

Fig.4

Regency® P36-4 Gas Log Fireplace 19