INSTALLATION
15)Connect the thermodisc wire harness to the new valve/module wire harness. Refer to the wiring diagram on next page for details.
16)Mount the thermodisc bracket to the adjustable bracket using 2 screws. Important: Thermodisc location is crucial, check the data badge to identify unit and secure to screw location accordingly.
22)Install the wire cover by fi tting the 3 clips onto the fl ange at the front of the fi rebox. See note below for P36 units.
Wire Cover
17)Remove the left side bottom hinge bracket by undoing the 2 screws.
Firebox Flange
18)Install the supplied hinge to the hinge bracket using 2 screws.
19)Slide the adjustable bracket to the bottom left corner and secure in place using the 2 screw holes on the fi rebox fl ange.
20)Secure loose wires using wire clips to the base of the fi rebox as far back as possible.
21)Place the manual control bracket back into it's original location and secure using 2 screws.
One clip shown in place
on fi rebox fl ange.
NOTE - P36 UNITS ONLY:
For the wire cover to fi t in place on the P36 the top half of the wire cover will need to be broken off by bending back and forth.
Bend Here
23)Align the bottom louver mounting tab with hinges on the left and right side and secure using 2 screws on each side.
24)Plug in power source.
25)Close the bottom louver.
NOTE:
The fan must run at minimum speed to prevent the unit from overheating which will cause automatic shutdown via the thermodisc safety switch.
26 | Regency® |
