INSTALLATION
10)Place the embers on the front of the burner tray in the places shown on the photo.
Place embers in these 3 locations
on the burner tray.
| |
| |
02 |
|
11)Test fire to ensure proper light off (make sure fl ame fl ows smoothly from one end of burner to the other). If there is any fl ame hesitation, check that area for any blockage of the burner ports.
Embers
STANDARD FLUSH DOOR
The standard flush door comes with a black frame. To install the frame, simply hook the top door fl ange onto the top of the unit and swing the door towards the unit, diagram 1.
Use the hook to pull the spring out until you can put the hook into the slot on the bottom door bracket. Repeat for 2nd spring. See diagram 3.
Flush Louvres
1)Install the top louvre by sliding the two bracket clips into the brackets located underneath the top of the fi rebox.
2)The bottom louvre has a hinge that is attached (2 screws per hinge) to the lip on bottom of the unit.
Diagram 1
Diagram 3
To remove the fl ush door, reverse the above steps.
Be careful that the glass gasket does not roll up; there must be a gap between the gasket and the door lip to ensure that the door sits securely on the unit. Diagram 2.
Optional
Flush Trim
Attach the round magnets to the back of the top trim piece and to the bottom trim piece, then attach trim to the top and bottom of Flush door.
Note: Top and bottom louvres are different.
Diagram 2
Regency® | 23 |