TP-Link TL-PA411 manual Fcc Statement, CE Mark Warning

Page 3
FCC STATEMENT

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних документів та вимогам, що передбачені чинними законодавчими актами України.

II

Image 3
Contents Rev 1910010651 TL-PA411 AV500 Mini Powerline AdapterCOPYRIGHT & TRADEMARKS CE Mark Warning FCC STATEMENTEN EN EN 61000-3-22006+A12009+A22009 EN EN DECLARATION OF CONFORMITYProduct Description AV500 Mini Powerline Adapter Rd, Nanshan, Shenzhen, ChinaAppendix A Troubleshooting CONTENTSPackage Contents Chapter 4 Using the Management UtilityTL-PA411 AV500 Mini Powerline Adapter Package Contents1.2 System Requirement Chapter 1 Introduction1.3 Important Safety Instructions 1.1 Conventions¾ If liquid has been spilled on the product Status Chapter 2 Connecting Mechanism2.2 LED Indicator 2.1 IntroductionDescription 2.3 Physical InterfaceTL-PA411 Interface2.5 Hardware Connection - Computer 2.4 Connection Instruction2.6 Hardware Connection - Internet TL-PA411 AV500 Mini Powerline Adapter Chapter 3 Installing Management Utility TL-PA411 AV500 Mini Powerline Adapter TL-PA411 AV500 Mini Powerline Adapter TL-PA411 AV500 Mini Powerline Adapter 4.1 Status Chapter 4 Using the Management Utility4.1.1 Set Local Device’s Network Name 4.2 Network 4.2.1 Rename the Remote Device/Enter Password Password is unnecessary to enter for renaming4.2.2 Add Device 4.3 Advanced 4.4 System 4.4.1 Upgrade Firmware To upgrade the devices firmware, follow these instructions 4.4.2 Reset Device4.4.3 Set All Devices’ Network Name 5.1 Pair Secure with 128 bits-AES Chapter 5 Advanced Feature How to Use the Pair Buttons5.2 Set Up a Powerline AV Network with the Pair Button Create a Powerline network using the Pair button:Join an existing Powerline AV Network Leave an existing Powerline AV NetworkThe sequence of Step 1 and Step 2 can be exchanged 2. The Ethernet LED does not light up. Ans. Check the following Appendix A Troubleshooting1. The Power LED does not light up. Ans. Check the following 3. The Powerline LED does not light up