TP-Link TL-PA4010P manual Hardware Connection Computer

Page 13

TL-PA4010PAV500 Powerline Adapter With AC Pass Through

2.3 Hardware Connection – Computer

For those computers you wish to be networked by Powerline Adapter, each of the computers must be properly connected with a Powerline Adapter through an Ethernet (RJ-45) cable.

Following are the steps to properly connect the Powerline Adapter to your computer:

1．Connect one end of the provided Ethernet (RJ-45) cable to the Powerline Adapter’s Ethernet port.

2．Connect the other end of the Ethernet (RJ-45) cable to you computer’s LAN port.

3．Plug the Powerline Adapter into a wall socket next to the computer.

4．Turn on your computer.

5．Check and confirm that the Power LED and Ethernet LED on the Powerline Adapter are ON. The hardware connection mechanism is shown below:

Note:

Do not connect the Powerline adapter to any extension lead, power strip, extension cord or surge protector, as these may degrade the network performance.

7

Image 13

Contents TL-PA4010P AV500 Powerline Adapter With AC Pass Through Copyright & Trademarks FCC Statement Safety Information Yang Hongliang Product Manager of International Business Declaration of ConformityContents Conventions Package ContentsIntroduction Important Safety InstructionsSystem Requirement Status Indication LED IndicatorDescription Physical InterfaceTL-PA4010PAV500 Powerline Adapter With AC Pass Through Introduction Connecting MechanismConnection Instruction Hardware Connection Computer  Note Hardware Connection InternetInstalling Management Utility TL-PA4010PAV500 Powerline Adapter With AC Pass Through TL-PA4010PAV500 Powerline Adapter With AC Pass Through TL-PA4010PAV500 Powerline Adapter With AC Pass Through Status Using the Management UtilitySet Local Device’s Network Name NetworkRename the Remote Device/Enter Password Add Device System AdvancedUpgrade Firmware Reset Device To upgrade the devices firmware, follow these instructionsSet All Devices’ Network Name Set Up a Secured Powerline AV Network with the Pair Button Advanced Feature How to Use the Pair ButtonsCreate a secured Powerline network using the Pair button： Pair Secure with 128 bits-AESLeave an existing secured Powerline AV Network Join an existing secured Powerline AV NetworkPower LED does not light up. Ans. Check the following Appendix a TroubleshootingPowerline LED does not light up Ethernet LED does not light up. Ans. Check the following