TP-Link TL-MR3220 manual System Requirements, Installation Environment Requirements

Page 15

TL-MR32203G/4G Wireless N Router User Guide

Chapter 2.Connecting the Router

2.1 System Requirements

¾Broadband Internet Access Service (DSL/Cable/Ethernet)

¾One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is connected directly to the Ethernet.)

¾PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors

¾TCP/IP protocol on each PC

¾Web browser, such as Microsoft Internet Explorer 5.0 , Netscape Navigator 6.0 or above

2.2 Installation Environment Requirements

¾Place the Router in a well ventilated place far from any heater or heating vent

¾Avoid direct irradiation of any strong light (such as sunlight)

¾Keep at least 2 inches (5 cm) of clear space around the Router

¾Operating Temperature: 0~40(32~104)

¾Operating Humidity: 10%~90%RH, Non-condensing

2.3 Connecting the Router

Before installing the Router, make sure your PC is connected to the Internet through the broadband service successfully. If there is any problem, please contact your ISP. After that, please install the Router according to the following steps. Don't forget to pull out the power plug and keep your hands dry.

1.Power off your Cable/DSL Modem, and the Router.

2.Locate an optimum location for the Router. The best place is usually at the center of your wireless network. The place must accord with the Installation Environment Requirements.

3.Adjust the direction of the antenna. Normally, upright is a good direction.

4.Connect the PC(s) or Switch/Hub in your LAN to the LAN Ports of the 3G/4G Router with Ethernet cable.

5.The 3G/4G Router supports both 3G/4G and WAN connection; so you can insert 3G/4G USB Modem to the USB port of the Router (as shown in Figure 2-1), or connect the DSL/Cable Modem to the WAN port of the Router (as shown in Figure 2-2). Please visit our website http://www.tp-link.com to get the latest USB modems compatibility, and we recommend you to check whether the modem in your hand has already been tested by us.

6.Connect the power adapter to the power socket on the Router, and the other end into an electrical outlet. The Router will start to work automatically.

7.Power on your Cable/DSL Modem.

-6-

Image 15
Contents TL-MR3220 3G/4G Wireless N Router Copyright & Trademarks FCC Statement Country Restriction Reason/remark CE Mark WarningKorea Warning Statements Yang Hongliang Product Manager of International Business Product Description 3G/4G Wireless N RouterContents 11.1 Backup & Restore Reboot Password System Log Statistics Package Contents Main Features Overview of the RouterConventions Panel Layout Front PanelIndication TL-MR3220 Rear PanelSide Panel Installation Environment Requirements Connecting the RouterSystem Requirements TL-MR32203G/4G Wireless N Router User Guide Quick Installation Guide TCP/IP ConfigurationLogin Windows ¾ WAN Only ¾ 3G/4G Preferred¾ 3G/4G Only ¾ WAN PreferredTL-MR32203G/4G Wireless N Router User Guide TL-MR32203G/4G Wireless N Router User Guide TL-MR32203G/4G Wireless N Router User Guide Status LoginWPS Quick SetupMethod One By PBC Push Button ConfigurationMethod Two Method Three Add a New Device II. By PIN Method One Enter the PIN into my RouterNext Method Two Enter the PIN from my Router Network Internet Access2 3G/4G Internet AccessConnection terminates Connecting last unless a new link requested TL-MR32203G/4G Wireless N Router User Guide To add 3G/4G USB Modem entries, follow the steps below 3 WANISP TL-MR32203G/4G Wireless N Router User Guide TL-MR32203G/4G Wireless N Router User Guide TL-MR32203G/4G Wireless N Router User Guide NSW / ACT nsw.bigpond.net.au TL-MR32203G/4G Wireless N Router User Guide TL-MR32203G/4G Wireless N Router User Guide MAC Clone 5 LAN Wireless Settings WirelessTL-MR32203G/4G Wireless N Router User Guide Wireless Security TL-MR32203G/4G Wireless N Router User Guide Encryption You can select either Automatic, or Tkip or AES Wireless MAC Filtering 26 Add or Modify Wireless MAC Address Filtering entry To modify or delete an existing entry Wireless AdvancedTL-MR32203G/4G Wireless N Router User Guide Wireless Statistics Dhcp SettingsDhcp Dhcp Clients List To Reserve IP addresses Address ReservationVirtual Servers ForwardingTo setup a virtual server entry 36 Add or Modify a Virtual Server Entry Port TriggeringTo add a new rule, follow the steps below 38 Add or Modify a Triggering Entry 3 DMZTo assign a computer or server to be a DMZ server UPnPBasic Security SecurityAdvanced Security TL-MR32203G/4G Wireless N Router User Guide 44 Local Management Local ManagementRemote Management Parental ControlTo add a new entry, please follow the steps below TL-MR32203G/4G Wireless N Router User Guide 48 Parental Control Settings Access ControlTo add a new rule, please follow the steps below RuleTL-MR32203G/4G Wireless N Router User Guide 53 Add or Modify a Host Entry HostTarget 56 Add or Modify an Access Target Entry To add a new schedule, follow the steps below ScheduleAdvanced Routing To add static routing entries Static Routing ListControl Settings Bandwidth ControlSystem Routing Table Rules List 14 IP & MAC Binding Binding SettingsEnter the MAC Address or IP Address To add IP & MAC Binding entries, follow the steps belowEnter the MAC Address and IP Address To find an existing entry, follow the steps belowDynamic DNS ARP ListComexe.cn Ddns Dyndns.org Ddns To set up for DDNS, follow these instructionsTL-MR32203G/4G Wireless N Router User Guide System Tools Time SettingsDiagnostic To configure the system manuallyTo configure the system automatically TL-MR32203G/4G Wireless N Router User Guide 79 Diagnostic Results Firmware UpgradeBackup & Restore Factory DefaultsPassword RebootSystem Log TL-MR32203G/4G Wireless N Router User Guide Statistics Total Modify ResetStatistics Table IP/MAC Address PacketsAppendix a FAQ Want to use Netmeeting, what do I need to do? Figure A-3 MAC CloneFigure A-5 Add or Modify a Virtual server Entry Want to build a WEB Server on the LAN, what should I do? Figure A-7 Basic SecurityFigure A-9 Virtual Servers Wireless stations cannot connect to the RouterInstall TCP/IP component Appendix B Configuring the PCsTL-MR32203G/4G Wireless N Router User Guide Figure B-3 ¾ Setting IP address manuallyFigure B-4 Now click OK to keep your settings Environmental Physical WirelessAppendix D Glossary TL-MR32203G/4G Wireless N Router User Guide Compatible 3G/4G USB Modem Tested in the field Appendix E Compatible 3G/4G USB Modem